Worth Data 701 RF manual Default Voice Messages, Recv Setup/Voice Please Wait

Default Voice Messages

Here are the default messages and the numbers they are recorded under:

Message Recorded		Message #
Prompt
	ITEM	#01
	QUANTITY	#02
Error messages
	LOW BATTERIES	#31
	CHANGE BATTERIES	#32
	TRANSMISSION FAILED	#33

Cloning Voice Messages and Setup from RF Terminal to RF Terminal

If you have several RF Terminals, you can record all of your voice messages in one RF Terminal and then simply “clone” them to your other RF Terminals. Cloning also copies the RF Terminal setup (except for Terminal ID).

You need 2 cables to clone RF Terminals; the Data Cloning Cable #F38 and the Voice Cloning Cable #T15. The Data Cloning Cable plugs into the

“Computer” port on each RF Terminal. This cable must be connected to clone properly.

One jack on the Voice Cloning Cable has two black rings on it – this end must plug in to the RECEIVING RF Terminal (the one you are transmitting to). Plug the single-banded jack end into the MASTER RF

Terminal (the one you are going to record from).

Once both cables are plugged in to both Terminals, go to the Setup Menu on both Terminals. Select 3 for Voice Operations from the menu.

The “Receiving” RF Terminal must be started first. On the receiving Terminal, press the 4 key for Cloning Receiver. The “Receiving” unit will display:

Recv Setup/Voice

Please Wait_

Now you can start the “Master” RF Terminal by pressing the 3 key for Cloning Master. The “Master” Terminal will display:

Xmit Setup/Voice

Please Wait_

During the cloning process, you will hear the voice messages played aloud as they are copied. The process takes about 75 seconds to complete. After the Terminals are done cloning, they will both display:

End of Cloning

Hit Any Key_

7-5