Worth Data 701 RF Speaker and Headphone Volume Controls, Automatic Check Back, Key Current Value

•RLx , where x indicates the ID of the relay (0-F) with which the terminal was last communicating (N if it was not a relay, but a base)

•6/6 is a 6 line terminal in 6 line mode; other possibilities are 6/4

SC=N indicates no Security Code is programmed (if Y, Security Code)

RF=NN refers to the radio processor firmware revision number

C=N indicates no Character mapping (if Y, beware, characters are remapped)

Press the STATUS key again to resume processing

Speaker and Headphone Volume Controls

Speaker

By selecting Speaker in the keyboard Setup Mode, you get to the options to control the Speaker/Beeper and Headphone volumes. If you are using headphones, you will want set the Speaker volume to 0 to conserve batteries. Volume settings possible are 0-9.The prompt for Speaker Volume is:

SPEAKER VOLUME

Enter 0-9 for Volume

Control

Current Value is: 5

The prompt for Headphone Volume is:

HEADPHONE VOLUME

Enter 0-9 for Volume

Control

Current Value is: 5

Other

Automatic Check Back

This parameter should not be changed under normal circumstances. After the host sends a prompt, the Terminal goes to sleep waiting on the operator to key or scan input in response to the prompt. It waits until the Automatic Shut Off time or until the operator responds. This parameter sets the time that the Terminal stops waiting on input from the operator, discards the current prompt, and goes back to the host to see if there is a change in instructions. If no change, the host must resend the prompt again because the Terminal has discarded the original prompt. The host now has the opportunity to change a prompt. The time can be set in increments of 5 seconds, up to 495 seconds. The default value is 00. The values possible for entry are 00-99. An entered 99 gives 99x5 seconds, or 495 seconds between check backs. The Terminal sends back an ASCII 07 for the data back to the host (ID ASCII 07 CR). This parameter's prompt is:

AUTOMATIC CHECK BACK

Key 00-99.

Current Value: 00

2-9