Worth Data 701 RF manual Using the keypad to setup the RF Terminal, RF Setup Batteries--4 BarCodes

More than one Setup Parameter can be changed before you scan END SETUP. For example, if you scanned START SETUP, then “Beep Tone”, then 3, then “Speaker Operation”, then 1, then END SETUP, this would

change the beep tone to “high”, and turn the speaker "off".

If you are using a Laser Scanner to setup the RF Terminal, the beam will often cover more than one bar code. Cover any adjacent bar codes before scanning, and then check the RF Terminal display to make sure the correct setting was entered.

Using the keypad to setup the RF Terminal

The RF Terminal can be setup via the Terminals' keypad by entering Setup Mode from the menu. Turn on the Terminal and press any key. You should see the SIGN ON? message:

SIGN ON?

KEY [YES/NO]?_

Press the NO key. The next prompt is the SETUP MODE? prompt:

SETUP MODE?

KEY [YES/NO]?_

Press the YES key. At this point, the terminal will ask for a password:

SETUP MODE

PASSWORD?_

Enter WDTRI on the keypad. The next item allows you to choose which item to configure:

R/F Terminal-------	>1
R/F Base Setup---	>2

Voice Operations->3

Press 1 to enter the RF Terminal Setup. Now you are in the RF Terminal Setup Menu and can choose from the following options:

RF Setup---	0	Batteries--4
BarCodes--	1	Speaker	---5
RS232-------	2	Other------	6
Date/Time--	3	Exit-------	F1

At this point, choose which group you want to configure. Most of the RF Terminal setup parameters are accessible from the either the keypad Setup Menu or the bar code Setup Menu. There are only 2 that are available only from the bar code Setup Menu while there are quite a few options that are available only from the keypad Setup. See the beginning of this chapter for a comparison of the two Setup Menus.

2-3