Worth Data 701 RF manual Battery Life Indicator, To change the AA batteries, Mm/dd/yy hhmm

Alkaline Batteries Detected, Recharge-

ables Are Specified Do Not Recharge

Battery Life Indicator

The R/F Terminal detects low AA batteries and displays the following message:

LOW BATTERIES

Finish, Sign Off

Change Batteries

Hit Any Key_

At this point you have approximately 2 minutes of operational time to finish your transaction (or note where you are leaving off if in the middle of a transaction) and sign off. After 2 minutes, the R/F Terminal displays:

CHANGE BATTERIES

UNIT SHUT DOWN_

This message displays for 20 seconds before the R/F Terminal signs off from the host (if signed on) and then shuts itself down. If you turn it back on without changing batteries, you may experience constant beeping, intermittent scanning, and very irritating symptoms that look like equipment failure.

Once you remove the batteries, you have 5 minutes to change them before you lose the date and time in the Real-Time Clock.

The R/F Terminal also has a battery life indicator that can be accessed while operating in ONE-WAY or TWO-WAY mode or while in the MENU. To display the remaining battery life of the AA batteries (as well as the date and time) press the STATUS key:

mm/dd/yy hh:mm

AAxBAT￿￿￿￿￿￿￿￿￿￿￿-zz%

x=a when Alkaline batteries are specified in Battery setup

x=n when NiMH or NiCad batteries specified in Battery setup zz=percent in numbers i.e. 99, 10, 05

Press the STATUS key again to resume processing.

To change the AA batteries:

1.Turn OFF the R/F Terminal.

2.Remove the battery holder door on the back of the R/F Terminal by pressing down on the grooved portion of the door and pushing outward.

3.Remove the old batteries and insert the new ones, making sure to orient the batteries with the positive (+) end facing down toward the bottom of the R/F Terminal.

1-5