Packing the printer for return to a Service Center

Should you need to return the printer for servicing, follow the packing instructions in this section

Note: Do not ship the power cord, printer cable, printer driver disks, user guide, print head and ink cartridges, or storage box unless instructed to do so.

1.Remove the print cartridge and place it in the print head storage box.

2.Close the printer cover and remove the paper output shelf.

3.Disconnect the power cord and the printer cable.

4.If you have the original box, use the original packing material, and go to step 10. If you do not have the original box, continue with step 5.

5.Completely wrap the printer in two layers of bubble wrap (minimum thickness of 12.3 mm or 0.5”) and tape the bubble wrap to keep it in place.

6.Select a corrugated box large enough to allow at least 50.8 mm (2”) between the bubble-wrapped printer and the walls of the box. Make sure the strength of the box is at least 275-lb. test.

7.Fill the bottom of the box with 75 to 100 mm (2” to 3”) of loose fill.

8.Place the bubble-wrapped printer in the center of the box.

63

Page 71
Image 71
Xerox Inkjet Printer manual Packing the printer for return to a Service Center