Xerox N4525 manual Single/All, Single/Specific, Xxxx.xxxx.xxxx

Control Panel Menus

Token Ring Menu Items (cont'd.)

Default Gateway	Sets the four byte Default Gateway address. (This menu item only appears if
	IP Address Res is set to static.)
	Values:
	xxx.xxx.xxx.xxx
	where xxx = 000 to 255
	Note: Once the control panel shows Default Gateway on the top line,
	use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
	location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
	can change characters within the address rather than having to re-enter the
	entire address
Port Timeout	Sets the time for determining when to end an incomplete print job and poll
	the next port in the polling sequence. The timeout also causes an implicit job
	end (such as Control D in PostScript or <ESC> E in PCL) and invokes the
	emulation functions associated with this action (e.g., form feed, reset, etc.).
	Values (in seconds):
	5 - 300 (default is 60)
	The value changes by 1 each time you press either Value key (labeled 3 or 7).
	Hold down either key to scroll quickly through the values.
Source Routing	Sets the source routing option.
	Values:
	Off (default)
	All
	Single/All
	Single/Specific
Speed	Sets the default ring speed of the Token Ring interface.
	Values (in MBits):
	4
	16 (default)
LAA	Sets the six byte Locally Administered Address.
	Values:
	xxxx.xxxx.xxxx
	where xx = 00 to FF hexadecimal
	where the range of xxxx.xxxx.xxxx is from
	4000 0000 0000 through 7FFF FFFF FFFF.
	Note: Once the control panel shows LAA on the top line, use the
	Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
	location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
	can change characters within the address rather than having to re-enter the
	entire address.

30 DocuPrint N4525 Network Laser Printer