Yamaha 01v owner manual 157, Basic Sampler with 2.9 second memory, To record and playback a sample

		Effects Parameters	157
FREEZE (Effect 2 only)
Basic Sampler with 2.9 second memory.
Parameter	Range	Description
		In MANUAL mode, recording is started by pressing
REC MODE	MANUAL, INPUT	the [ENTER] button. In INPUT mode, recording is
		triggered by an input signal.
START	*1	Playback start point in milliseconds
[SAMPLE]	0–131070	Playback start point in samples
		In MOMENT mode, the sample plays for the moment
		that the [ENTER] button is pressed. In CONT. mode,
	MOMENT, CONTI.,	playback continues once the [ENTER] button has
PLY MODE		been pressed. In INPUT mode, playback continues
	INPUT
		once it’s been triggered by an input signal. The
		number of times the sample plays is set using the
		LOOP NUM parameter.
END	*1	Playback end point in milliseconds
[SAMPLE]	0–131070	Playback end point in samples
LOOP	0–100	Number of times the sample plays
NUM
LOOP	*1	Loop start point in milliseconds
[SAMPLE]	0–131070	Loop start point in samples
TRG LVL	–60 to 0 dB	Input trigger level (i.e., the signal level required to
		trigger recording or playback)
		Recording delay. For plus values, recording starts after
TRG DLY	–1000 to +1000 ms	the trigger is received. For minus values, recording
		starts before the trigger is received.
		Once playback has been triggered, subsequent
TRG MASK	0–1000 ms	triggers are ignored for the duration of the TRG MASK
		time.
MIDI TRG	OFF, C1–C6, ALL	Sample playback can be triggered using MIDI Note
		on/off messages.
PITCH	–12 to +12 semitones	Playback pitch shift
FINE	–50 to +50 cents	Playback pitch shift fine

1. 0.0–2972.1 ms (fs=44.1 kHz), 0.0 ms–2730.6 ms (fs=48 kHz)

To record and playback a sample

1.Send a channel signal to Effect 2, and then recall the Freeze effect.

See “Using the Effects” on page 123 and “Recalling Effects Programs” on page 134.

2.Use the [EFFECT 2] button to locate EFFECT 2 page 1, as shown below.

3.Select the (REC) switch, and then press the [ENTER] button. Note that the previous sampler is deleted at this point.

The REC switch appears highlighted, and input signal can be heard.

01V—Owner’s Manual