Yamaha 01v owner manual Editing the Dynamics Processors

166 Chapter 13—Dynamics Processors

Editing the Dynamics Processors

Dynamics processors are edited on the DYNAMICS page 1, as shown below.

1.Use the [DYNAMICS] button to locate DYNAMICS page 1, as shown below.

2.Use [SEL] buttons 1 through 16 and MASTER to select channels.

3.Use the cursor buttons to select the parameters, and the PARAMETER wheel or [–1/DEC] and [+1/INC] buttons to set them.

TYPE—This is the name of the type of dynamics processor currently selected: COMP, GATE, DUCKING, EXPAND, COMPANDER-(H), or COMPANDER-(S).

ON/OFF—This switch is used to turn on or off the dynamics processors. While DYNAMICS page 1 is displayed, the [ENTER] button turns the dynamics processor on or off regardless of the cursor position.

KEY IN—This parameter is used to select the trigger source for the dynamics proces- sors, and can be set to SELF (i.e., the signal being processed is used as the trigger signal) or triggered by a signal from another input channel from CH1 through CH16.

CURVE—This window shows the curve of the dynamics processor, pro- viding a visual indication of how it’s set. The horizontal axis corresponds to the input signal and the vertical axis corresponds to the output signal.

A straight line at 45 degrees from the bottom left corner indicates that the input signal will pass through the dynamics processor unaffected. This can be seen when, for example, a compressor is set with a compression ratio of 1:1.

PARAMETER—These controls are used to adjust the dynamics processor’s parameters. The number and type of parameters available depends on the type of dynamics proces- sor selected.

Meters—The GR meter indicates the amount of gain reduction being applied to the selected channel. Next to this are level meters for the selected channel and its neighbor. The GR meter works from top to bottom. For the COMP, DUCKING, EXPAND, and COMPANDER types, the GR meter displays the amount of gain reduction. For the GATE type, the processor is active when the input signal is below the threshold, so the GR meter displays the amount of gain reduction when the input signal is below the threshold, and when there is no input signal.

The dynamics processors parameters are explained in detail on page 167.

01V—Owner’s Manual