|
| Appendix | |
| Troubleshooting | ||
|
|
| |
Troubleshooting |
|
| |
|
|
| |
|
|
| |
Symptom | Possible Cause & Solution | Page | |
|
|
| |
Overall |
|
| |
|
|
| |
| Noise can be produced by nearby electronic devices being turned on |
| |
Clicks and pops occur occasionally. | or off, electrical motors, or similar sources. Try to use an electrical | – | |
output as far away from the suspected noise source as possible. If no | |||
|
| ||
| cause can be found, contact your Yamaha service center. |
| |
|
|
| |
Interference from mobile phones, radios, | Interference can be caused by mobile phones, radio transmitters, or |
| |
similar devices operating in the vicinity of the instrument. If the noise | – | ||
television sets, and similar devices. | |||
seems to be excessive contact your Yamaha service center. |
| ||
|
| ||
|
|
| |
The instrument causes interference with | This instrument can cause interference if operated too close to radio |
| |
or television receivers. Move the instrument further away from the | – | ||
radios or television sets. | |||
receiving devices if interference occurs. |
| ||
|
| ||
|
|
| |
No response to long button presses. | The | ||
Reduce the time setting. | |||
|
| ||
|
|
| |
No Sound |
|
| |
|
|
| |
| Local Control may be off. If off it should be turned on. | ||
|
|
| |
| The volume may be turned all the way down. Turn it up to an | ||
| appropriate level. | ||
|
|
| |
No Sound | A pair of headphones or external speakers may be connected. | – | |
|
| ||
| The mute function may be engaged. Turn it off. | ||
|
|
| |
| MIDI connection is not established with the Master |
| |
| does not operate properly, even though "Slave Mode" is selected in | – | |
| the "Preference menu". |
| |
|
|
| |
| The instrument’s | – | |
| (i.e. more than 32 notes are being played at once). | ||
|
| ||
|
|
| |
| In all modes other than the Push Mode, only one note of a given pitch |
| |
| can play at the same time in a single layer. When a second note of the | – | |
| same pitch is played in the same layer, any previous note of the same | ||
|
| ||
Some notes cut off. | pitch is turned off before the new note is played. |
| |
|
|
| |
| The Sound Length setting is too long. The |
| |
| tone generator (each note uses two notes of the instrument’s |
| |
| polyphony), so when a long Sound Length is specified the maximum | – | |
| polyphony (number of simultaneous notes) can be easily exceeded, |
| |
| with the result that the notes may not play as expected. |
| |
|
|
| |
Pitch and Voices |
|
| |
|
|
| |
The scale assigned to the vertical/ | A scale other than the default Ionian scale has been selected. Select | ||
horizontal axis does not sound right. | the Ionian scale. | ||
| |||
|
|
| |
When a new block is selected and the |
|
| |
voice is changed, the voice used in the | The same voice applies to the | ||
first layer changes as well. |
|
| |
|
|
| |
Data Storage and Initialization |
|
| |
|
|
| |
Settings are not retained at the next | Save settings you want retained using the Save As Default function. | ||
|
| ||
|
|
| |
Some parameters are not initialized when | Some parameters saved using the Save As Default function are not | ||
the Reset All Blocks function is executed. | initialized. | ||
| |||
|
|
| |