NOTE: Rewind option required.
Refer to Figure 17.
1.Remove the rewind plate from the front of the printer (if installed). Store it on the two mounting screws on the inside of the front panel.
2.Open the printhead.
3.Slide the media guide and media supply guide as far from the printer frame as possible. Flip down the media supply guide.
4.Load media as shown.
5.When loading media, allow approximately 36” (914 mm) of media to extend past the
6.Remove the hook from the rewind spindle. If you are using a core, slide it onto the rewind spindle until it is flush against the guide plate.
7.Wind the label backing around either the 3” (76 mm) core or the rewind spindle and reinstall the hook.
8.Flip up the media supply guide. Slide in the media guide and media supply guide so they just touch, but not restrict, the edge of the roll.
Before closing the printhead, make sure:νThe media is positioned against the inside guides.
νThe media is taut and parallel with itself and the pathway when wound onto the rewind spindle/core.
9.Close the printhead.
10.To discard the label backing from the rewind spindle, refer to “Removing the Label Backing Material” on page 38.
28 | Zebra |