Zebra Technologies XiIII Leaving the Setup Mode

Leaving the Setup Mode

You can leave the program mode at any time by pressing the SETUP/EXIT key. The “SAVE CHANGES” display will appear. There are five choices, described below. Pressing the LEFT or RIGHT BLACK OVAL key displays other choices and pressing the NEXT/SAVE key selects the displayed choice.

νPERMANENT - Permanently saves the changes. Values are stored in the printer even when power is turned off.

νTEMPORARY - Saves the changes until changed again or until power is turned off.

νCANCEL - Cancels all changes since pressing the SETUP/EXIT key except the darkness and tear-off settings (if they were changed).

νLOAD DEFAULTS - Loads factory defaults. The factory defaults are shown on the following pages.

NOTE: Loading factory defaults will require printer calibration.

νLOAD LAST SAVE - Loads values from the last permanent save.

Zebra XiIII-Series User’s Guide

Contents

User's Guide Page Table of Contents Introduction Calibrating the Printer Establishing Communication Printer Basics Configuration Routine Care and Adjustment Troubleshooting Specifications Appendix Index Introduction Unpacking and Inspection Reporting Damage Storage Media and Ribbon Requirements Power Cord Printer Anatomy Calibrating the Printer Types of Media Non-ContinuousWeb Media Non-ContinuousBlack Mark Media Continuous Media Choosing the Print Mode Tear-off Peel-off cutter rewind Loading the Media Positioning the Media Sensors Transmissive Sensor Page Black Mark Sensor Loading the Ribbon Operator Controls POWER Switch Front Panel Configuring the Printer Configuring the Software or Printer Driver Media and Ribbon Calibration Page Printing a Test Label Page Establishing Communication Cabling Requirements NOTES: Printer Basics Front Panel Display Front Panel Keys Front Panel Lights Roll Media Loading Tear-OffMode Peel-OffMode Before closing the printhead, make sure: Page Rewind Mode (for Printers Without the Cutter Option) Page Cutter Mode Page Rewind Mode (for Printers With the Cutter Option) Page Fanfold Media Loading Page Removing the Label Backing Material Ribbon Loading Page Ribbon Removal Page Configuration Changing Password-ProtectedParameters Leaving the Setup Mode Configuration and Calibration Sequence Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Routine Care and Adjustment Cleaning the Exterior Cleaning the Interior Cleaning the Printhead and Platen Roller Cleaning the Sensors Cleaning the Snap Plate CAUTION: Use care to not bend, twist, or otherwise deform the loops Page Cleaning the Cutter Module Lubrication Fuse Replacement Page Adjustments Toggle Positioning Printhead Pressure Adjustment Media Sensor Position Adjustment Page Troubleshooting Error Condition Head Open Error Condition Head Element Bad Warning Ribbon In Warning Head Too Hot Warning Head Cold Warning Cutter Jammed Out of Memory Print Quality Problems General Print Quality Issues Gray lines on blank labels with no consistent pattern Light, consistent vertical lines running through all of the labels Intermittent creases on the left and right edges of the labels Wrinkled Ribbon Communications Page Printer Diagnostics Power-OnSelf Test Additional Printer Self Tests CANCEL Key Self Test PAUSE Key Self Test FEED Key Self Test FEED Key and PAUSE Key Self Test Communications Diagnostics Test Additional Printer Diagnostics Page Specifications Zebra Programming Language (ZPL II®) Bar Codes General Specifications Printing Specifications Ribbon Specification Media Specifications Power Line Cord Specifications Appendix RS-232Interconnections DB-9S DB-25P DCE DTE RS-422/RS-485Interconnections Parallel Port Interconnections Page Index