Press | Display Shows |
| Action/Explanation |
|
| Setting Print Width | Press the RIGHT BLACK OVAL key to |
|
| increase the value, press the LEFT BLACK OVAL key to decrease | |
|
| the value. To change the unit of measurement, press the LEFT | |
|
| BLACK OVAL key until the unit of measurement is active, then | |
|
| press the RIGHT BLACK OVAL key to toggle to a different unit of | |
| PRINT WIDTH | measure (inches, mm, or dots). | |
| Default:, Range: The default and range of acceptable values vary | ||
|
| ||
|
| depending on what printer you have. Refer to “Printing | |
|
| Specifications” on page 90 for further information about the | |
|
| ranges available for your model. | |
|
| Print width determines the printable area across the width of the | |
|
| label. |
|
|
|
| |
|
| Setting Maximum Length Press the LEFT BLACK OVAL key to | |
|
| decrease the value, press the RIGHT BLACK OVAL key to | |
|
| increase the value. |
|
|
| Default:, Range: The default and range of acceptable values vary | |
|
| depending on your printer’s configuration. Values are adjustable | |
|
| in 1” (25.4 mm) increments. | |
| MAXIMUM | Maximum length is used in conjunction with the calibration | |
| LENGTH | ||
| procedure. The value of this setting determines the maximum | ||
|
| ||
|
| label length that will be used during the media portion of the | |
|
| calibration process. Only a few labels are required to set media | |
|
| sensors. Always set the value that is closest to, but not lower | |
|
| than, the length of the label you are using. For example, if the | |
|
| length of the label is 14.5 inches (368 mm), set the parameter for | |
|
| 15.0 inches (381 mm). | |
|
|
|
|
48 | Zebra |