Troubleshooting
LED Error Conditions and WarningsError Condition Ribbon OutProblem | Solution | |
In thermal transfer mode, the ribbon is | Load the ribbon correctly. See “Ribbon Loading” on | |
not loaded or loaded incorrectly. | page 39. | |
|
| |
In thermal transfer mode, the ribbon | Perform the media and ribbon sensor calibration (see | |
sensor is not sensing correctly loaded | ||
page 17). | ||
ribbon. | ||
| ||
|
| |
| Put the printer in direct thermal mode via the front | |
In direct thermal mode, when ribbon is | panel and remove ribbon (if loaded). | |
| ||
not used: | Ensure that the printer driver or software settings are | |
| ||
| correctly set (if applicable). | |
|
|
Problem | Solution | |
The media is not loaded or loaded | Reload the media. Refer to “Roll Media Loading” on | |
incorrectly. | page 27. | |
|
| |
The media sensor is not adjusted | Check the position of the upper and lower media | |
sensors. See “Positioning the Media Sensors” on | ||
properly. | ||
page 10. | ||
| ||
|
| |
| Either load the correct media or set the printer for the | |
| correct media type via the front panel. | |
The printer is set for |
| |
Ensure that the printer driver or software settings are | ||
media, but continuous media is loaded. | ||
correctly set (if applicable). | ||
| ||
|
| |
| Calibrate the printer (see page 17). | |
|
| |
The incorrect media sensor is being | Via the front panel, check the sensor type to ensure | |
that the correct one is used for the media loaded. See | ||
used. | ||
page 16. Calibrate the printer (see page 17). | ||
| ||
|
|
Zebra | 75 |