5.5.5Set Mode Command
Syntax:
192.168.1.1 sys> set mode [fastnormal]
where
fast =
normal =
Fast makes use of the “tag” subset of the IEEE 802.1Q standard to identify the source port of a frame and speed traffic through a service gateway.
Normal switches frames using a layer 2 switch (IEEE 801.1D) transparent bridge standard. Use normal mode when you are using a regular gateway.
This command lets you set the network module into fast or normal mode. Determine which mode you are using by entering the info command. Fast mode allows only one port per PVID. Use normal mode and the 802.1Q VLAN commands (see Chapter 10 ) to configure VLANs or PVIDs with multiple ports.
Enable fast mode only when you are using a service gateway.5.6Secured Host Commands
Allow up to ten remote administrators to access your
5.6.1Secured Host Command
Syntax:
192.168.1.1 sys> secured host [<mode>]
where
<mode> = "enable" or "disable".
If <mode>= disable (default), then anyone may access your
If <mode>= enable, then only those computers with IP addresses specified by you may access your
This command enables/disables the secured host function. To display current secured host settings, simply enter the command secured host.
5.6.2Secured Host Add Command
Syntax:
192.168.1.1 sys> secured host add <host IP>
where
<host IP> = | The IP address of a secured host. |
This command adds the IP address of a secured host. You may add up to ten IP addresses.
System Commands |