6.6.16Set Ports Command
Syntax:
192.168.1.1 gshdsl> set ports <profile name>
where |
|
<profile name> = | The profile that defines the minimum and maximum transfer rates for this |
| port. |
This CI command is like the Set Port Command described in section 6.6.15 except that this command configures all G.SHDSL ports to have a specified profile. Enter the list ports command to view the status of all ports.
6.6.17Set PVC Command
Syntax:
192.168.1.1 gshdsl> set pvc <port #> <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx vci>]
where
<port #> | = | A port number, from 1 to 8. |
<multiplexing mode> | = | Either “llc” or “vc" |
<tx vpi> | = | The VPI setting of the G.SHDSL port for use with a TX based |
|
| network. |
<tx vci> | = | The VCI setting for the G.SHDSL port for use with a TX based |
|
| network. |
<rx vpi> | = | The VPI setting for the G.SHDSL port for use with Rx based |
|
| networks. |
<rx vci> | = | The VCI setting for the G.SHDSL port for use with Rx based |
|
| networks. |
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual G.SHDSL port.
6.6.18Set PVCs Command
Syntax:
192.168.1.1 gshdsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx vci>]
where
<multiplexing mode>= | Either “llc” or “vc”. | ||
<tx vpi> | = | The VPI setting of the G.SHDSL ports for use with a TX based | |
|
| network. | |
|
|
| |
G.SHDSL Commands |
|
| |