|
| |
<multiplexing mode> = | Either “llc” or “vc" | |
<tx vpi> | = | The VPI setting of the ADSL port for use with a Tx based network |
<tx vci> | = | The VCI setting for the ADSL port for use with a Tx based network |
<rx vpi> | = | The VPI setting for the ADSL port for use with Rx based networks |
<rx vci> | = | The VCI setting for the ADSL port for use with Rx based networks |
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL port.
7.5.22Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx vci>]
where
multiplexing mode = either “llc” or “vc”
<tx vpi> | = The VPI setting of the ADSL ports for use with a Tx based network | ||
<tx vci> | = The VCI setting for the ADSL ports for use with a Tx based network | ||
<rx | vpi> | = | The VPI setting for the ADSL ports for use with Rx based networks |
<rx | vpi> | = | The VCI setting for the ADSL ports for use with Rx based networks |
The <rx vpi> and | <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx | ||
settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the ADSL ports at once.
7.5.23Show PVC Command
Syntax:
192.168.1.1 adsl> show pvc <port number>
where
<port number> = A port number, from 1 to 8.
The show pvc command allows you to display the PVC parameters of an individual ADSL port.
ADSL Commands |