ZyXEL Communications 1000 6.6.8List Port Command, 6.6.9List Ports Command, Table 6-2List Port Command - <State> Parameter

		IES-1000 User’s Guide
		errors are found.
<SES>	=	Severely Errored Second. The total number of one-second intervals when at least fifty
		CRC errors are found.
<LOSWS>	=	Loss of Sync Word Failure Second. Displays the total number of one-second intervals
		when one or more SHDSL LOSW errors are found.
<UAS>	=	Unavailable Second. The total number of one-second intervals when the G.SHDSL
		line is unavailable.
<downN>	=	The number of times the G.SHDSL line has been dropped.

6.6.8List Port Command

Syntax:

192.168.1.1 gshdsl> list port <port #>

where

<port #> = The port number, from 1 to 8

This command displays information about the line speed, state and the line rate parameter of a G.SHDSL port.

An example is shown next.
192.168.1.1 gshdsl> list port 6
Port=6 Speed(Cmax/Act)=2048/			0Kbps Cmin=192 State=Disabled/Down
where
<Cmax>	=	Configured maximum line speed in Kbps. The maximum G.SHDSL line speed you
		configured. For details about configuring this parameter see section 6.6.15.
<Act>	=	The actual G.SHDSL line speed in Kbps.
<Cmin>	=	This is the configured minimum line speed in Kbps for this port. The minimum
		G.SHDSL line speed you configured.
<State>	=	Displays the state of an individual G.SHDSL port and the G.SHDSL line. If this
		parameter is disabled, then the G.SHDSL port and line is forced down. If this
		parameter is enabled, then the G.SHDSL port and line may be up or down. See next
		for more details.

Table 6-2 List Port Command - <State> Parameter

STATE	STATUS
Enabled	Up
	Down
Disabled	Forced down

6.6.9List Ports Command

Syntax:

192.168.1.1 gshdsl> list ports

G.SHDSL Commands 6-5