IES-1000 User’s Guide

9.3Basic Commands

9.3.1Config Save Command

Syntax:

192.168.1.1 bridge> config save

This command saves the bridge configuration into nonvolatile memory. You must use this command to save any configurations that you make, otherwise the IES-1000 will return to its default settings when it is restarted.

Do not turn off your IES-1000 while saving your configuration.

9.3.2Device Command

Syntax:

192.168.1.1 bridge> device

This command shows information on all bridge ports.

9.3.3Status Command

Syntax:

192.168.1.1 bridge> status

This command displays the bridge status.

9.4MAC filter Commands

Use MAC filter commands to filter incoming frames based on MAC (Media Access Control) address(es) that you specify. If you do not use this command, your IES-1000 will not filter frames. MAC filter commands are listed next. You may specify up to five MAC addresses per port.

9.4.1MAC filter Command

Syntax:

192.168.1.1 bridge> macfilter [<port>]

where

port =

A bridge port number.

This command displays the MAC filtering status and the fixed source MAC addresses on a port or on all ports if no port is specified.

9-2

Bridge Commands