11.2.2Regen Port Command
Syntax:
192.168.1.1 vlan1q> regen port [<port #> <user priority> <regened priority>]
where
<port #> | = | A bridge port number. Valid parameter range = [1 – 9]. |
<user priority> | = | The user priority for a frame received on this port. Valid |
|
| parameter range = [0 – 7 or *], where 0 is the lowest priority, 7 is |
|
| the highest priority and * means all user priorities. |
<regened priority> = | The regenerated user priority the incoming user priority is | |
|
| mapped to for <port #>. Valid parameter range = [0 - 7], |
|
| where 0 is the lowest priority and 7 is the highest priority. |
This command changes the priority of a tagged frame from a specified ingress port from the original user priority to the regened priority.
To display the regeneration table, simply use the Regen Port command without parameters, as shown next.
192.168.1.1 vlan1q> regen port
IEEE 802.1p Priority Commands |