<tx vci> | = | The VCI setting for the G.SHDSL ports for use with a TX based |
|
| network. |
<rx vpi> | = | The VPI setting for the G.SHDSL ports for use with Rx based |
|
| networks. |
<rx vpi> | = | The VCI setting for the G.SHDSL ports for use with Rx based |
|
| networks. |
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the G.SHDSL ports at once.
6.6.19Show PVC Command
Syntax:
192.168.1.1 gshdsl> show pvc <port #>
where
<port #> = | A port number, from 1 to 8. |
This command allows you to display the PVC parameters of an individual G.SHDSL port
6.6.20Show PVCs Command
Syntax:
192.168.1.1 gshdsl> show pvcs
This command allows you to display the PVC parameters of all G.SHDSL ports.
6.6.21Display All G.SHDSL Line Information
Syntax:
192.168.1.1 gshdsl> monitor [<start port> [<stop port>]]
where
<start port> | = | The first port number in a range of ports for which you want to display |
|
| line information. 1 is used if you leave this blank. |
<stop port> | = | The last port number in a range of ports for which you want to display |
|
| line information. 8 is used if you leave this blank. |
This command displays all G.SHDSL line information. Information is updated every five seconds. Press any key and then press [ENTER] to stop updating information. Use monitor without any port numbers to display line information for every port.
6.6.22Set Central Side Port Bonding Command
Syntax:
G.SHDSL Commands |