ZyWALL 10/50 Internet Security Gateway

TFTP [-i] host get rom-0 config.rom

where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the ZyWALL IP address, “get” transfers the file source on the ZyWALL (rom-0 name of the configuration file on the ZyWALL) to the file destination on the computer and renames it config.rom.

21.2.8 GUI-Based TFTP Clients

The following table describes some of the fields that you may see in GUI-Based TFTP clients.

 

Table 21-3 General Commands for GUI-Based TFTP Clients

COMMAND

DESCRIPTION

 

 

Host

Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL’s default IP address

 

when shipped.

 

 

Send/Fetch

Use “Send” to upload the file to the ZyWALL and “Fetch” to back up the file on your

 

computer.

 

 

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration file

 

(*.rom extension) on your computer.

 

 

Remote File

This is the filename on the ZyWALL. The filename for the firmware is “ras” and for the

 

configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

 

 

Abort

Stop transfer of the file.

 

 

Refer to section 21.2.5 to read about configurations that disallow TFTP and FTP over WAN.

21.2.9 Backup Via Console Port

Backup configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

Step 1. Display menu 24.5 and enter “y” at the following screen.

Ready to backup Configuration via Xmodem.

Do you want to continue (y/n):

Figure 21-3 System Maintenance — Backup Configuration

21-6

Firmware and Configuration File Maintenance