ZyXEL Communications 10, 50 21.3.3 Restore Using FTP Session Example, 21.3.4 Restore Via Console Port, Step, Step, Step, Step, Step, Step, Step, Step

ZyWALL 10/50 Internet Security Gateway

Step 3. Press [ENTER] when prompted for a username.

Step 4. Enter your password as requested (the default is “1234”).

Step 5. Enter “bin” to set transfer mode to binary.

Step 6. Find the “rom” file (on your computer) that you want to restore to your ZyWALL.

Step 7. Use "put" to transfer files from the Prestige to the computer, for example, "put config.rom rom- 0" transfers the configuration file "config.rom" on your computer to the Prestige. See earlier in this chapter for more information on filename conventions.

Step 8. Enter “quit” to exit the FTP prompt. The ZyWALL will automatically restart after a successful restore process.

21.3.3 Restore Using FTP Session Example

ftp> put config.rom rom-0 200 Port command okay

150 Opening data connection for STOR rom-0

226 File received OK

221 Goodbye for writing flash

ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit

Figure 21-8 Restore Using FTP or TFTP Session Example

Refer to section 21.2.5 to read about configurations that disallow TFTP and FTP over WAN.

21.3.4 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

Step 1. Display menu 24.6 and enter “y” at the following screen.

Ready to restore Configuration via Xmodem.

Do you want to continue (y/n):

Figure 21-9 System Maintenance — Restore Configuration

Step 2. The following screen indicates that the Xmodem download has started.

Firmware and Configuration File Maintenance 21-9