Chapter 7 WAN Setup
7.5 Internet Access Setup
Use this screen to change your ZyXEL Device’s WAN remote node settings. Click Network > WAN > Internet Access Setup. The screen differs by the encapsulation you select.
See Section 7.1 on page 101 for more information.
Figure 50 Internet Access Setup (PPPoE)
The following table describes the labels in this screen.
Table 23 Internet Access Setup
LABEL | DESCRIPTION |
General |
|
|
|
Mode | Select Routing (default) from the |
| computers to share an Internet account. Otherwise select Bridge. |
Encapsulation | Select the method of encapsulation used by your ISP from the |
| box. Choices vary depending on the mode you select in the Mode field. |
| If you select Bridge in the Mode field, select either PPPoA or RFC 1483. |
| If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET |
| ENCAP or PPPoE. |
User Name | (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your |
| ISP assigned. If assigned a name in the form user@domain where domain |
| identifies a service name, then enter both components exactly as given. |
|
|
Password | (PPPoA and PPPoE encapsulation only) Enter the password associated with the |
| user name above. |
|
|
Service Name | (PPPoE only) Type the name of your PPPoE service here. |
|
|
106 |
| |
| ||
|
|
|