Chapter 21 Bandwidth Management
The following table describes the labels in this screen.
Table 134 Bandwidth Management: General
LABEL | DESCRIPTION |
Active | Select the check box to enable bandwidth management. |
|
|
Auto | Select the check box to enable Automatic Traffic Classifier (ATC). ATC assigns each |
Classifier | packet to a bandwidth management class based on its size, since |
| applications such as VoIP tend to have smaller packet sizes than |
| applications such as FTP. When ATC is enabled, traffic with a smaller packet size is |
| assigned a higher priority than traffic with a larger packet size. |
|
|
Apply | Click Apply to save your settings back to the ZyXEL Device. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
21.7 Bandwidth Management Rule Setup
You must use the Bandwidth Management General screen to enable bandwidth management before you can configure rules.
Click Advanced > Bandwidth MGMT > Rule Setup to open the following screen.
Figure 189 Bandwidth Management: Rule Setup
The following table describes the labels in this screen.
Table 135 Bandwidth Management: Rule Setup
LABEL | DESCRIPTION |
Direction | Select LAN to apply bandwidth management to traffic that the ZyXEL Device |
| forwards to the LAN. |
| Select WAN to apply bandwidth management to traffic that the ZyXEL Device |
| forwards to the WAN. |
| Select WLAN to apply bandwidth management to traffic that the ZyXEL Device |
| forwards to the WLAN. |
|
|
Service | Select a service for your rule or you can select User define to go to the screen |
| where you can define your own. |
|
|
Priority | Select a priority from the drop down list box. Choose High, Mid or Low. |
|
|
334 |
| |
| ||
|
|
|