Lexicon SDP-40 Understanding Listening Mode Selection, Input Setup Menu, Mode Buttons, Music

Page 32

Basic Operation

JBL

UNDERSTANDING LISTENING MODE SELECTION

There are three different methods of selecting listening modes in the Main Zone:

The INPUT SETUP Menu

The Mode up and down buttons on the front panel or the MODE +/- buttons on the remote control

The Mode Family Selection Buttons on the remote control:

MUSIC

Listening mode selection only applies to the Main Zone.

INPUT SETUP MENU

This type of listening mode selection occurs each time a listening mode is changed in the INPUT SETUP menu, and each time an input is selected using the input selection buttons on the front panel or the remote control.

The INPUT SETUP menu can be used to select a preferred 2-channel, Dolby Digital, and dts(-ES) listening mode for each input. When an input type is recognized, the unit automatically defaults to the appropriate listening mode. (See page 3-3 for more information about the INPUT SETUP menu. See Section 5 for more information about listening modes.)

For example, the 2-CH parameter on the INPUT SETUP menu is set to LOGIC7 FILM and the DOLBY D parameter is set to 5.1 LOGIC7 MUSIC. When the input type changes from 2-channel to Dolby Digital, the listening mode will automatically change from LOGIC7 FILM to 5.1 LOGIC7 MUSIC.

MODE BUTTONS

This type of listening mode selection occurs each time the Mode Up and Down buttons are pressed on the front panel, or the MODE +/- buttons are pressed on the remote control. This type of mode scrolling allows auditioning of all listening modes available for the current input type.

Pressing the Mode Up/MODE + button selects the previous listening mode on the list. Pressing the Mode Down/MODE - button selects the next listening mode on the list. 2-channel listening modes are listed on page 3-10. Dolby Digital and dts(-ES) listening modes are listed on page 3-11. These lists are not visible on the on-screen and front panel displays during scrolling.

Note:

When the input type changes, the unit will automatically revert to the default listening modes selected in the INPUT SETUP menu. If USE LAST is selected in the INPUT SETUP menu when the input format changes, the unit will revert to the listening mode that was last used for the input type.

2-16

Image 32
Contents SDP-40 Important Safety Instructions JBL Synthesis Introduction Audio Controls Menu Portuguese Instruções DE Segurança IMPORTANTEsDeutsch Español Instrucciones Importantes DE SeguridadFrançais Instructions DE Sûreté Importantes Italiano Importanti Norme DI SicurezzaDansk Vigtig Information OM Sikkerhed SuomiNorsk Viktig Informasjon OM Sikkerhet US Unpacking and Inspection Getting Started Getting Started Highlights Using the Documentation User Guide SymbolsLocation Considerations Navigating the MenusExit Restoring FACTORY-DEFAULT SettingsTWO-LINE Status Basic Operation Blue LED Front PanelIR Receiver Main Off deactivates the Main Zone Basic Operation Basic Operation Rear Panel Remote Control Command Bank SelectionBank StandbyLight Bank SelectionInput Selection ButtonsBlue OSDMode + VOL +Menu StatMute Arrows 2CHMode FamilyUnderstanding the Zones Understanding Listening Mode Selection Input Setup MenuMode Buttons MusicMode Family Selection Buttons Channel DigitalSetup Menu Setup Volume ControlsRear Panel Config DisplaysInput Setup DVD1Name Restore Default NameName Digital Digital COAX-1Default Parameter Value Values AnalogAnlg in LVL AutoManual Anlg in LVL AutoVideo VideoComponent Film Dts-ESInputs Main Advanced ZONE2 Advanced Record Advanced DVD1 D Mode Main Advanced Input Select AUTO, ANALOG, Digital Analog Bypass ON, OFFMain Advanced ZONE2 AdvancedComponent OSD ON, OFF VideoInput Select AnalogRecord Advanced Anlg in LVL Digital Bypass ON, OFFDIG OUT Rate RecordSpeaker Setup Custom Setup Determining Crossover SettingsFrequency Response Curves Lowpass FilterCustom Setup Front L/RFULL, 30Hz to 120Hz, THX 80Hz CenterSide L/R FULL, 30Hz to120Hz, THX 80Hz, NoneRear L/R Side L/RSUB L/R SUB XoverSUB L/R SUB XoverLFE ON, OFF LFE OFFParameter Value Values Synthesis 7CH SetupDefault Setup Speaker DistancesLevels Calibration Internal Noise TestDacs Calibration SUB Limiters Levels CalibrationDacs Calibration CAL Noise ON, OFF Limiter ON, OFFLimit ADJ LFE Limiter ON, OFFStereo Inputs Stereo & 5.1 AnlgPosition Display Setup ON-SCREEN DisplayStatus Front Panel Display Sync DelayON-SCREEN Display Edit Custom Name Custom NameEdit Custom Name Custom Name OFFVolume Control Setup Main PWR onMute Level Zone PWR onTrigger Setup Remote OperationProgram Operation TriggerSetup ModesAudio Cntrl Lock OptionsAudio Controls Menu Audio Controls Bass Audio ControlsBass Treble Audio Controls TrebleTilt EQ Audio Controls Tilt EQLoudness ON, OFF Audio Controls Audio Controls BalanceAudio Controls Fader Audio Controls ZONE2 BalanceRecord Balance Audio Controls Record BalanceMode Adjust Menu Mode Adjust L7 Film Mode AdjustListening Mode Descriptions LOGIC7 Film Mode Adjust L7 TV Mode Adjust MusicLOGIC7 TV LOGIC7 MusicMode Adjust PL Mode Adjust L7 PRO LogicDolby PRO Logic II THX Dolby PRO LogicDolby PRO Logic II Music Mode Adjust L7 PL II MusicDefault Parameter Values Default Value Mode Adjust 2-CHANNEL Mode Adjust PartyChannel PartyMode Adjust Mono Default ParameterValueValuesMode Adjust Mono Logic MonoMono Surround Mode Adjust Mono SurroundMode Adjust 5.1L7 Film Mode Adjust 5.1L7 TV Mode Adjust 5.1L7 MusicMode Adjust 5.1 SUR EX THX Surround EX or 5.1 THXTHX Surround EX THXMode Adjust L7 Digital Mode Adjust 5.1 2-CHANNELDolby Digital 2-CHANNELMono Mode Adjust 5.1 MonoMode Adjust 5.1 Mono Logic Mode Adjust 5.1 Mono Surr Dts-ES LOGIC7 filmDts-ES THX Mode AdjustDts-ES LOGIC7 Music Mode Adjust 2-CHAN Dts and dts-ESDts-ES 2-CHANNEL DtsMode Adjust 5.1 Bypass Mode Adjust 2CH BypassBypass Channel BypassCustom VS Preset Reset ModeOutput Levels CustomStatus Menus 2CH Status Menu2CH Bypass Status Menu Parameter ValuesAnalog Status Menu Dolby Digital Status MenuBypass Status Menu Mode Parameter Descriptions Dts Status MenuSpkr Enhance ON, OFF Academy Filter ON, OFFBass Enhance ON, OFF Center MIXChannels Cntr DLY SamplesDimension CTR WidthCustom Effect LVLLFE MIX Master LevelMode Output LevelsSound Stage Surr RolloffSurround DLY Surround EX ON, OFFTroubleshooting and Maintenance Troubleshooting Humming Sound is Present in the Audio RF Interference is Present in the Audio or VideoUnit is Exhibiting Erratic Behavior If ALL Else FailsRoutine Maintenance Appendix Specifications Audio Inputs and OutputsPerformance Main Zone Performance Zone 2 and Record ZoneVideo Inputs and Outputs Performance Composite & S-videoPerformance Component Video OtherDeclaration of Conformity Menu Tree On page A-6From page A-5 DVD1 Input Setup Name None Side L/R Speakers Dacs Calibration Film Auto Azimuth Additional Listening Mode Menus Input Type BYPInstallation Worksheet Input SetupRear Panel Config Index Index Name Tilt EQ Synthesis Limited Warranty JBL Synthesis