Lexicon SDP-40 manual Channel Bypass, Mode Adjust 5.1 Bypass, Mode Adjust 2CH Bypass

Page 90

The MODE ADJUST Menu

JBL

5.1 BYPASS

MODE ADJUST 5.1 BYPASS

•Designed for playback of 5.1-channel analog input sources, such as DVD-A or SACD players.

•When selected, the (L) input is sent to the FRONT L output. The (R) input is sent to the FRONT R output. The (C) input is sent to the CENTER output. The (SUB) input is sent to the SUBWOOFER L/R and LFE outputs. The (LS) input is sent to the SIDE and REAR L outputs. The (RS) input is sent to the SIDE and REAR R outputs.

The 5.1 BYPASS listening mode is not available unless, and will be automatically selected when, all of the following conditions are met:

•5 STEREO & 5.1 ANLG is selected on the REAR PANEL CONFIG menu (see page 3-30).

•The ANALOG IN parameter on the INPUT SETUP menu is set to 5.1 ANALOG (see page 3-6).

•The INPUT SELECT parameter on the MAIN ADV menu is set to either AUTO or ANALOG (see page 3-13). When set to AUTO, no digital input types can be present.

•The ANALOG BYPASS parameter on the MAIN ADV menu is set to ON (see page 3-13).

	Default
Parameter	Value	Values

OUTPUT LEVELS	See page 5-17 for more information

CUSTOM	See page 5-17 for more information

An alphabetical listing of parameter descriptions begins on page 5-20.

2-CHANNEL BYPASS

MODE ADJUST 2CH BYPASS

•Designed for playback of 2-channel analog input sources.

•When selected, the input signal bypasses internal processing and bypasses to the FRONT L/R outputs.

The 2CH BYPASS listening mode is not available unless, and will be automatically selected when, all of the following conditions are met:

•The ANALOG IN parameter on the INPUT SETUP menu is set to the connector utilized by the input source (see page 3-6).

•The INPUT SELECT parameter on the MAIN ADV menu is set to either AUTO or ANALOG (see page 3-13). When set to AUTO, no digital input types can be present.

•The ANALOG BYPASS parameter on the MAIN ADV menu is set to ON (see page 3-13).

No parameters are available for the 2CH BYPASS listening mode.

5-16

Image 90

Contents SDP-40 Important Safety Instructions JBL Synthesis Introduction Audio Controls Menu Portuguese Instruções DE Segurança IMPORTANTEsDeutsch Español Instrucciones Importantes DE SeguridadFrançais Instructions DE Sûreté Importantes Italiano Importanti Norme DI SicurezzaDansk Vigtig Information OM Sikkerhed SuomiNorsk Viktig Informasjon OM Sikkerhet US Unpacking and Inspection Getting Started Getting Started Highlights Location Considerations Using the DocumentationUser Guide Symbols Navigating the MenusRestoring FACTORY-DEFAULT Settings TWO-LINE StatusExit Basic Operation Front Panel IR ReceiverBlue LED Main Off deactivates the Main Zone Basic Operation Basic Operation Rear Panel Remote Control Command Bank SelectionLight BankStandby Bank SelectionInput Selection ButtonsBlue OSDMode + VOL +Stat MuteMenu Arrows 2CHMode FamilyUnderstanding the Zones Mode Buttons Understanding Listening Mode SelectionInput Setup Menu MusicMode Family Selection Buttons Channel DigitalSetup Menu Rear Panel Config SetupVolume Controls DisplaysInput Setup DVD1Restore Default Name NameName Digital Digital COAX-1Anlg in LVL Default Parameter Value ValuesAnalog AutoManual Anlg in LVL AutoVideo VideoComponent Dts-ES InputsFilm Main Advanced ZONE2 Advanced Record Advanced DVD1 D Mode Main Advanced Input Select AUTO, ANALOG, Digital Analog Bypass ON, OFFComponent OSD ON, OFF Main AdvancedZONE2 Advanced VideoInput Select AnalogRecord Advanced DIG OUT Rate Anlg in LVLDigital Bypass ON, OFF RecordSpeaker Setup Custom Setup Determining Crossover SettingsFrequency Response Curves Lowpass FilterFULL, 30Hz to 120Hz, THX 80Hz Custom SetupFront L/R CenterRear L/R Side L/RFULL, 30Hz to120Hz, THX 80Hz, None Side L/RSUB L/R SUB L/RSUB Xover SUB XoverLFE ON, OFF LFE OFFSynthesis 7CH Setup DefaultParameter Value Values Setup Speaker DistancesLevels Calibration Internal Noise TestDacs Calibration Levels Calibration Dacs CalibrationSUB Limiters Limit ADJ CAL Noise ON, OFFLimiter ON, OFF LFE Limiter ON, OFFStereo Inputs Stereo & 5.1 AnlgDisplay Setup ON-SCREEN Display StatusPosition Sync Delay ON-SCREEN DisplayFront Panel Display Edit Custom Name Edit Custom NameCustom Name Custom Name OFFMute Level Volume Control SetupMain PWR on Zone PWR onProgram Operation Trigger SetupRemote Operation TriggerAudio Cntrl SetupModes Lock OptionsAudio Controls Menu Audio Controls BassAudio Controls Bass Tilt EQ TrebleAudio Controls Treble Audio Controls Tilt EQAudio Controls Fader Loudness ON, OFF Audio ControlsAudio Controls Balance Audio Controls ZONE2 BalanceRecord Balance Audio Controls Record BalanceMode Adjust Menu Mode Adjust Listening Mode Descriptions LOGIC7 FilmMode Adjust L7 Film LOGIC7 TV Mode Adjust L7 TVMode Adjust Music LOGIC7 MusicDolby PRO Logic II THX Mode Adjust PLMode Adjust L7 PRO Logic Dolby PRO LogicMode Adjust L7 PL II Music Default Parameter Values Default ValueDolby PRO Logic II Music Channel Mode Adjust 2-CHANNELMode Adjust Party PartyMode Adjust Mono Logic Mode Adjust MonoDefault ParameterValueValues MonoMode Adjust Mono Surround Mode Adjust 5.1L7 FilmMono Surround Mode Adjust 5.1L7 TV Mode Adjust 5.1L7 MusicTHX Surround EX Mode Adjust 5.1 SUR EXTHX Surround EX or 5.1 THX THXDolby Digital Mode Adjust L7 DigitalMode Adjust 5.1 2-CHANNEL 2-CHANNELMode Adjust 5.1 Mono Mode Adjust 5.1 Mono LogicMono Mode Adjust 5.1 Mono Surr Dts-ES LOGIC7 filmMode Adjust Dts-ES LOGIC7 MusicDts-ES THX Dts-ES 2-CHANNEL Mode Adjust 2-CHANDts and dts-ES DtsBypass Mode Adjust 5.1 BypassMode Adjust 2CH Bypass Channel BypassOutput Levels Custom VS PresetReset Mode Custom2CH Bypass Status Menu Status Menus2CH Status Menu Parameter ValuesDolby Digital Status Menu Bypass Status MenuAnalog Status Menu Spkr Enhance ON, OFF Mode Parameter DescriptionsDts Status Menu Academy Filter ON, OFFChannels Bass Enhance ON, OFFCenter MIX Cntr DLY SamplesCustom DimensionCTR Width Effect LVLMode LFE MIXMaster Level Output LevelsSurround DLY Sound StageSurr Rolloff Surround EX ON, OFFTroubleshooting and Maintenance Troubleshooting Unit is Exhibiting Erratic Behavior Humming Sound is Present in the AudioRF Interference is Present in the Audio or Video If ALL Else FailsRoutine Maintenance Appendix Performance Main Zone SpecificationsAudio Inputs and Outputs Performance Zone 2 and Record ZonePerformance Component Video Video Inputs and OutputsPerformance Composite & S-video OtherDeclaration of Conformity Menu Tree On page A-6From page A-5 DVD1 Input Setup Name None Side L/R Speakers Dacs Calibration Film Auto Azimuth Additional Listening Mode Menus Input Type BYPInstallation Worksheet Input SetupRear Panel Config Index Index Name Tilt EQ Synthesis Limited Warranty JBL Synthesis