Lexicon SDP-40 Loudness ON, OFF Audio Controls, Audio Controls Balance, Audio Controls Fader

The AUDIO CONTROLS Menu

JBL

LOUDNESS	(ON, OFF)
AUDIO CONTROLS	LOUDNESS

LOUDNESS controls the amount of low-frequency boost that is automatically applied to the FRONT L/R, CENTER, SUBWOOFER L/R, and LFE outputs. When set to ON, loudness compensation is automatically applied based on the current volume level. As volume is decreased, the amount of boost is automatically increased. The loudness contour is optimized for sources calibrated to Dolby reference levels. When set to OFF, loudness compensation is not applied.

The graph pictured below shows the frequency response that is automatically applied when Main Zone volume is adjusted.

dB

0

0

+12

0

0

+9

0

0

+6

0

0

+3

0

0

10	20	50	100	200	500	1k	2k	5k	10k	20k
					Hz

BALANCE

AUDIO CONTROLS BALANCE

BALANCE controls the left-to-right balance of the Main Zone. When BALANCE is selected, a horizontal graph (pictured on page 4-2) will appear on the screen below the parameter. This graph illustrates the position at which the current setting falls within the entire parameter range. Press the up MENU arrow to move the setting toward the right, and the down MENU arrow to move the setting toward the left. Press the left MENU arrow to close the graph and return to the AUDIO CONTROLS menu.

FADER

AUDIO CONTROLS FADER

FADER controls the front-to-back balance of the Main Zone. When FADER is selected, a horizontal graph (pictured on page 4-2) will appear on the screen below the parameter. This graph illustrates the position at which the current setting falls within the entire parameter range. Press the up MENU arrow to move the setting forward, and the down MENU arrow to move the setting back- ward. Press the left MENU arrow to close the graph and return to the AUDIO CONTROLS menu.

ZONE2 BALANCE

AUDIO CONTROLS ZONE2 BALANCE

ZONE2 BALANCE controls the left-to-right balance of the ZONE2 AUDIO OUTPUTS. When ZONE2 BALANCE is selected, a horizontal graph (pictured on page 4-2) will appear on the screen below the parameter. This graph illustrates the position at which the current setting falls within the entire parameter range. Press the up MENU arrow to move the setting toward the right, and the down MENU arrow to move the setting toward the left. Press the left MENU arrow to close the graph and return to the AUDIO CONTROLS menu.

4-4