Lexicon SDP-40 manual Dts-ES, Inputs, Film

Page 43

The SETUP Menu

JBL

MAIN MENU

MODE ADJUST AUDIO CONTROLS SETUP

SETUP

INPUTS

SPEAKERS

REAR PANEL CONFIG DISPLAYS VOLUME CONTROLS TRIGGERS

LOCK OPTIONS

INPUT SETUP

DVD1

DVD2

LD

TV

SAT

VCR

CD

PVR

GAME

TAPE

TUNER

AUX

DVD1 INPUT SETUP

NAME

 

DVD1

DIGITAL IN

COAX-1

ANALOG IN

NONE

ANLG IN LVL

AUTO

VIDEO IN

S-VIDEO-1

COMPONENT IN

 

1

 

 

 

 

 

 

2-CH

L7

FILM

 

D

5.1 L7

FILM

 

 

 

 

dts L7

FILM

 

 

 

 

MAIN ADVANCED

ZONE2 ADVANCED

RECORD ADVANCED

DVD1 2-CH MODE

FILM

TV

MUSIC

PL II

PRO LOGIC II PL II MUSIC

PRO LOGIC 2-CHANNEL PARTY MONO MONO LOGIC MONO SURROUND USE LAST

DVD1 is used as an example in this illustration, and will continue to be used as an example throughout this section. Whenever “DVD1” appears as a step in a menu path, any other input may be substituted.

2-CH

DOLBY D

SETUP

INPUTS

DVD1

2-CH

SETUP

INPUTS

DVD1

D

Selecting 2-CH accesses the 2-CH MODE menu (pictured above), which can be used to select the listening mode for 2-channel input types. Listening modes are explained in further detail in Section 5.

Selecting DOLBY D accesses the DOLBY D MODE menu (pictured on the top of the next page), which can be used to select the listening mode for Dolby Digital input types. Listening modes are explained in further detail in Section 5.

Note:

When the 2-CH parameter is set to USE LAST, pressing the 2CH button on the remote control selects the 2-CHANNEL listening mode. However, pressing the 2CH button again does not select the previous listening mode. To deselect the 2-CHANNEL listening mode, press another mode family selection button on the remote control or reselect the input. (See page 2-# for more information about the 2CH button.)

dts(-ES)

SETUP INPUTS DVD1

Selecting dts(-ES) accesses the dts(-ES) MODE menu (pictured on the bottom of the next page), which can be used to select the listening mode for dts(-ES) input types. Listening modes are explained in further detail in Section 5.

3-10

Image 43
Contents SDP-40 Important Safety Instructions JBL Synthesis Introduction Audio Controls Menu Instruções DE Segurança IMPORTANTEs PortugueseEspañol Instrucciones Importantes DE Seguridad DeutschItaliano Importanti Norme DI Sicurezza Français Instructions DE Sûreté ImportantesSuomi Dansk Vigtig Information OM SikkerhedNorsk Viktig Informasjon OM Sikkerhet US Unpacking and Inspection Getting Started Getting Started Highlights Navigating the Menus Using the DocumentationUser Guide Symbols Location ConsiderationsTWO-LINE Status Restoring FACTORY-DEFAULT SettingsExit Basic Operation IR Receiver Front PanelBlue LED Main Off deactivates the Main Zone Basic Operation Basic Operation Rear Panel Command Bank Selection Remote ControlBank Selection BankStandby LightSelection Buttons InputOSD BlueVOL + Mode +Mute StatMenu 2CH ArrowsFamily ModeUnderstanding the Zones Music Understanding Listening Mode SelectionInput Setup Menu Mode ButtonsChannel Digital Mode Family Selection ButtonsSetup Menu Displays SetupVolume Controls Rear Panel ConfigDVD1 Input SetupName Restore Default NameName Digital COAX-1 DigitalAuto Default Parameter Value ValuesAnalog Anlg in LVLAnlg in LVL Auto ManualVideo VideoComponent Inputs Dts-ESFilm Main Advanced ZONE2 Advanced Record Advanced DVD1 D Mode Main Advanced Analog Bypass ON, OFF Input Select AUTO, ANALOG, DigitalVideo Main AdvancedZONE2 Advanced Component OSD ON, OFFAnalog Input SelectRecord Advanced Record Anlg in LVLDigital Bypass ON, OFF DIG OUT RateDetermining Crossover Settings Speaker Setup Custom SetupLowpass Filter Frequency Response CurvesCenter Custom SetupFront L/R FULL, 30Hz to 120Hz, THX 80HzSide L/R Side L/RFULL, 30Hz to120Hz, THX 80Hz, None Rear L/RSUB Xover SUB L/RSUB Xover SUB L/RLFE OFF LFE ON, OFFDefault Synthesis 7CH SetupParameter Value Values Speaker Distances SetupInternal Noise Test Levels CalibrationDacs Calibration Dacs Calibration Levels CalibrationSUB Limiters LFE Limiter ON, OFF CAL Noise ON, OFFLimiter ON, OFF Limit ADJStereo & 5.1 Anlg Stereo InputsStatus Display Setup ON-SCREEN DisplayPosition ON-SCREEN Display Sync DelayFront Panel Display Custom Name OFF Edit Custom NameCustom Name Edit Custom NameZone PWR on Volume Control SetupMain PWR on Mute LevelTrigger Trigger SetupRemote Operation Program OperationLock Options SetupModes Audio CntrlAudio Controls Menu Bass Audio ControlsAudio Controls Bass Audio Controls Tilt EQ TrebleAudio Controls Treble Tilt EQAudio Controls ZONE2 Balance Loudness ON, OFF Audio ControlsAudio Controls Balance Audio Controls FaderAudio Controls Record Balance Record BalanceMode Adjust Menu Listening Mode Descriptions LOGIC7 Film Mode AdjustMode Adjust L7 Film LOGIC7 Music Mode Adjust L7 TVMode Adjust Music LOGIC7 TVDolby PRO Logic Mode Adjust PLMode Adjust L7 PRO Logic Dolby PRO Logic II THXDefault Parameter Values Default Value Mode Adjust L7 PL II MusicDolby PRO Logic II Music Party Mode Adjust 2-CHANNELMode Adjust Party ChannelMono Mode Adjust MonoDefault ParameterValueValues Mode Adjust Mono LogicMode Adjust 5.1L7 Film Mode Adjust Mono SurroundMono Surround Mode Adjust 5.1L7 Music Mode Adjust 5.1L7 TVTHX Mode Adjust 5.1 SUR EXTHX Surround EX or 5.1 THX THX Surround EX2-CHANNEL Mode Adjust L7 DigitalMode Adjust 5.1 2-CHANNEL Dolby DigitalMode Adjust 5.1 Mono Logic Mode Adjust 5.1 MonoMono Dts-ES LOGIC7 film Mode Adjust 5.1 Mono SurrDts-ES LOGIC7 Music Mode AdjustDts-ES THX Dts Mode Adjust 2-CHANDts and dts-ES Dts-ES 2-CHANNELChannel Bypass Mode Adjust 5.1 BypassMode Adjust 2CH Bypass BypassCustom Custom VS PresetReset Mode Output LevelsParameter Values Status Menus2CH Status Menu 2CH Bypass Status MenuBypass Status Menu Dolby Digital Status MenuAnalog Status Menu Academy Filter ON, OFF Mode Parameter DescriptionsDts Status Menu Spkr Enhance ON, OFFCntr DLY Samples Bass Enhance ON, OFFCenter MIX ChannelsEffect LVL DimensionCTR Width CustomOutput Levels LFE MIXMaster Level ModeSurround EX ON, OFF Sound StageSurr Rolloff Surround DLYTroubleshooting and Maintenance Troubleshooting If ALL Else Fails Humming Sound is Present in the AudioRF Interference is Present in the Audio or Video Unit is Exhibiting Erratic BehaviorRoutine Maintenance Appendix Performance Zone 2 and Record Zone SpecificationsAudio Inputs and Outputs Performance Main ZoneOther Video Inputs and OutputsPerformance Composite & S-video Performance Component VideoDeclaration of Conformity On page A-6 Menu TreeFrom page A-5 DVD1 Input Setup Name None Side L/R Speakers Dacs Calibration Film Auto Azimuth Input Type BYP Additional Listening Mode MenusInput Setup Installation WorksheetRear Panel Config Index Index Name Tilt EQ Synthesis Limited Warranty JBL Synthesis