Lexicon SDP-40 manual Side L/R, FULL, 30Hz to120Hz, THX 80Hz, None, Rear L/R

Page 54

SDP-40

The SETUP Menu

MAIN MENU

MODE ADJUST AUDIO CONTROLS SETUP

SETUP

INPUTS

SPEAKERS

REAR PANEL CONFIG DISPLAYS VOLUME CONTROLS TRIGGERS

LOCK OPTIONS

SPEAKER SETUP

CUSTOM SETUP SYNTHESIS 7CH SETUP SPEAKER DISTANCES LEVELS CALIBRATION

		R	SR	RR
		80Hz	80Hz	80Hz
		C
		80Hz
	M	L	SL	RL
	SUB	L	SL	RL
	SUB
80Hz		80Hz	80Hz	80Hz

CUSTOM SETUP

FRONT L/R	80Hz
CENTER	80Hz

SIDE L/R	80Hz

REAR L/R	80Hz
SUB L/R	MONO
SUB XOVER	80Hz
LFE	OFF

	SIDE L/R SPEAKERS

	FULL
	30Hz		REAR L/R SPEAKERS
	40Hz
	40Hz
	50Hz		FULL
	60Hz		30Hz
	70Hz		40Hz
	80Hz		50Hz
	THX 80Hz		60Hz
	90Hz		70Hz
	100Hz		80Hz
	110Hz		THX 80Hz
	120Hz		90Hz
	NONE		100Hz
			110Hz
			110Hz
			120Hz
			NONE

SIDE L/R

(FULL, 30Hz to120Hz, THX 80Hz, NONE)

The SIDE L/R parameter sets the crossover setting for the MAIN AUDIO OUTPUTS labelled SIDE L/R. When set to FULL, the unit sends a full-range audio signal to the SIDE L/R outputs. When set to a numerical crossover setting, the unit activates a crossover at the selected frequency. Choose the setting closest to the low- frequency rating of the side left and right speakers. See pages 3-18 and 3-19 for more information about crossover settings.

When set to NONE, the unit redirects side channel signals to the REAR L/R outputs. When both the SIDE L/R and REAR L/R parameters are set to NONE, the unit redirects surround channel signals to the FRONT L/R outputs.

REAR L/R

(FULL, 30Hz to 120Hz, THX 80Hz, NONE)

The REAR L/R parameter sets the crossover setting for the MAIN AUDIO OUTPUTS labelled REAR L/R. When set to FULL, the unit sends a full-range audio signal to the REAR L/R outputs. When set to a numerical crossover setting, the unit activates a crossover at the selected frequency. Choose the setting closest to the low- frequency rating of the rear left and right speakers. See pages 3-18 and 3-19 for more information about crossover settings.

When set to NONE, the unit redirects rear channel signals to the SIDE L/R outputs. When both the SIDE L/R and REAR L/R parameters are set to NONE, the unit redirects surround channel signals to the FRONT L/R outputs.

3-21

Image 54

Contents SDP-40 Important Safety Instructions JBL Synthesis Introduction Audio Controls Menu Portuguese Instruções DE Segurança IMPORTANTEsDeutsch Español Instrucciones Importantes DE SeguridadFrançais Instructions DE Sûreté Importantes Italiano Importanti Norme DI SicurezzaDansk Vigtig Information OM Sikkerhed SuomiNorsk Viktig Informasjon OM Sikkerhet US Unpacking and Inspection Getting Started Getting Started Highlights Location Considerations Using the DocumentationUser Guide Symbols Navigating the MenusRestoring FACTORY-DEFAULT Settings TWO-LINE StatusExit Basic Operation Front Panel IR ReceiverBlue LED Main Off deactivates the Main Zone Basic Operation Basic Operation Rear Panel Remote Control Command Bank SelectionLight BankStandby Bank SelectionInput Selection ButtonsBlue OSDMode + VOL +Stat MuteMenu Arrows 2CHMode FamilyUnderstanding the Zones Mode Buttons Understanding Listening Mode SelectionInput Setup Menu MusicMode Family Selection Buttons Channel DigitalSetup Menu Rear Panel Config SetupVolume Controls DisplaysInput Setup DVD1Restore Default Name NameName Digital Digital COAX-1Anlg in LVL Default Parameter Value ValuesAnalog AutoManual Anlg in LVL AutoVideo VideoComponent Dts-ES InputsFilm Main Advanced ZONE2 Advanced Record Advanced DVD1 D Mode Main Advanced Input Select AUTO, ANALOG, Digital Analog Bypass ON, OFFComponent OSD ON, OFF Main AdvancedZONE2 Advanced VideoInput Select AnalogRecord Advanced DIG OUT Rate Anlg in LVLDigital Bypass ON, OFF RecordSpeaker Setup Custom Setup Determining Crossover SettingsFrequency Response Curves Lowpass FilterFULL, 30Hz to 120Hz, THX 80Hz Custom SetupFront L/R CenterRear L/R Side L/RFULL, 30Hz to120Hz, THX 80Hz, None Side L/RSUB L/R SUB L/RSUB Xover SUB XoverLFE ON, OFF LFE OFFSynthesis 7CH Setup DefaultParameter Value Values Setup Speaker DistancesLevels Calibration Internal Noise TestDacs Calibration Levels Calibration Dacs CalibrationSUB Limiters Limit ADJ CAL Noise ON, OFFLimiter ON, OFF LFE Limiter ON, OFFStereo Inputs Stereo & 5.1 AnlgDisplay Setup ON-SCREEN Display StatusPosition Sync Delay ON-SCREEN DisplayFront Panel Display Edit Custom Name Edit Custom NameCustom Name Custom Name OFFMute Level Volume Control SetupMain PWR on Zone PWR onProgram Operation Trigger SetupRemote Operation TriggerAudio Cntrl SetupModes Lock OptionsAudio Controls Menu Audio Controls BassAudio Controls Bass Tilt EQ TrebleAudio Controls Treble Audio Controls Tilt EQAudio Controls Fader Loudness ON, OFF Audio ControlsAudio Controls Balance Audio Controls ZONE2 BalanceRecord Balance Audio Controls Record BalanceMode Adjust Menu Mode Adjust Listening Mode Descriptions LOGIC7 FilmMode Adjust L7 Film LOGIC7 TV Mode Adjust L7 TVMode Adjust Music LOGIC7 MusicDolby PRO Logic II THX Mode Adjust PLMode Adjust L7 PRO Logic Dolby PRO LogicMode Adjust L7 PL II Music Default Parameter Values Default ValueDolby PRO Logic II Music Channel Mode Adjust 2-CHANNELMode Adjust Party PartyMode Adjust Mono Logic Mode Adjust MonoDefault ParameterValueValues MonoMode Adjust Mono Surround Mode Adjust 5.1L7 FilmMono Surround Mode Adjust 5.1L7 TV Mode Adjust 5.1L7 MusicTHX Surround EX Mode Adjust 5.1 SUR EXTHX Surround EX or 5.1 THX THXDolby Digital Mode Adjust L7 DigitalMode Adjust 5.1 2-CHANNEL 2-CHANNELMode Adjust 5.1 Mono Mode Adjust 5.1 Mono LogicMono Mode Adjust 5.1 Mono Surr Dts-ES LOGIC7 filmMode Adjust Dts-ES LOGIC7 MusicDts-ES THX Dts-ES 2-CHANNEL Mode Adjust 2-CHANDts and dts-ES DtsBypass Mode Adjust 5.1 BypassMode Adjust 2CH Bypass Channel BypassOutput Levels Custom VS PresetReset Mode Custom2CH Bypass Status Menu Status Menus2CH Status Menu Parameter ValuesDolby Digital Status Menu Bypass Status MenuAnalog Status Menu Spkr Enhance ON, OFF Mode Parameter DescriptionsDts Status Menu Academy Filter ON, OFFChannels Bass Enhance ON, OFFCenter MIX Cntr DLY SamplesCustom DimensionCTR Width Effect LVLMode LFE MIXMaster Level Output LevelsSurround DLY Sound StageSurr Rolloff Surround EX ON, OFFTroubleshooting and Maintenance Troubleshooting Unit is Exhibiting Erratic Behavior Humming Sound is Present in the AudioRF Interference is Present in the Audio or Video If ALL Else FailsRoutine Maintenance Appendix Performance Main Zone SpecificationsAudio Inputs and Outputs Performance Zone 2 and Record ZonePerformance Component Video Video Inputs and OutputsPerformance Composite & S-video OtherDeclaration of Conformity Menu Tree On page A-6From page A-5 DVD1 Input Setup Name None Side L/R Speakers Dacs Calibration Film Auto Azimuth Additional Listening Mode Menus Input Type BYPInstallation Worksheet Input SetupRear Panel Config Index Index Name Tilt EQ Synthesis Limited Warranty JBL Synthesis