American Dryer Corp ADG-60 service manual Dryer is making scraping noise at basket tumbler area

Page 37

3.Restriction in exhaust duct work.

T.Dryer is making scraping noise at basket (tumbler) area

1.Check for objects caught in basket (tumbler) wrapper area.

2.Basket (tumbler) is out proper alignment

a.Check gap between the front panel and the basket (tumbler) front set screws may have come loose and basket (tumbler) walked forwards or backwards.

3.Loose or broken basket (tumbler) tie rod.

4.Broken basket (tumbler support).

U.Excessive noise or vibration

1.Dryer is not leveled properly.

2.Impellor (fan) out of balance or broken.

3.Loose basket (tumbler) tie rod.

4.Basket (tumbler) is out of adjustment or adjustment bolts (hardware) are loose.

5.Loose motor or motor mount assembly.

V.Basket (tumbler) turns too fast (as opposed to other baskets [tumblers])

1.Foreign objects caught between basket (tumbler) belt and motor shaft.

W.Computer registers more time than what was inserted (i.e. 99 mins. one coin)

1.Replace optic switch (P/N: 137056)

2.Replace computer board.

33

Image 37

Contents VAC Phase Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Electrical Troubleshooting Section CleaningLubrication AdjustmentsTo Remove Lint Drawer To remove gas valve train assemblyTo remove control middle or lint lower door To Remove Control Box To Remove and Replace Lint Drawer Switch AssemblyTo Remove Front Panel To Remove and Replace Sensor Bracket and Components To Remove or Replace Belt Loctite To Remove or Replace Motor Reverse steps 1 through Loctite To Remove or Replace Impellor Fan Belt and Idler Tension AdjustmentTo Replace Dual Control Microprocessor DMC Computer Fan Belt and Tension AdjustmentTo Replace Coin Acceptor To Replace Touchpad KeypadBasket Tumbler Alignment Vertical To Replace either Motor RelayBasket Tumbler Alignment Lateral To Replace Basket tumbler or Basket tumbler Support Loctite Important Never strike the shaft directly with a hammer To Replace Basket tumbler Support Pillow Block BearingPage To Replace Basket Tumbler Support Flange Bearing To Replace 330º F Burner Hi-Limit Switch Thermostat To Replace Main Door Switch To Replace Sail SwitchTo Replace Direct Spark Ignition DSI Module BB. To Replace Gas Valve AA. To Replace Ignitor and ProbeDD. To Replace Coin Vault Discontinue power to the dryerEE. To Remove Main Door FF. To Install New Main Door GlassGG. To Replace Main Door Gasket HH. To Replace Main Door HingeNo L.E.D. Display TroubleshootingDMC computer L.E.D. display reads dSFL DMC computer L.E.D. display reads Sefl DMC computer L.E.D. display reads HotIf dryer is equipped with optional battery back up Condensation on main door glass Dryer operates, but is taking to long to dryExcessive noise or vibration Dryer is making scraping noise at basket tumbler areaNo Display Condition Electrical TroubleshootingNo Start Condition Motor Doesnt Turn No Heat Condition Gas DOOr Condition DSFL Condition Data Label Technical InformationHOW to USE a Manometer Using a ManometerClcc E.D. Display CodesFill Diagnostic L.E.D. Display Failure Codes Phase 5 System DiagnosticsPhase 5 DMC Computer Relay Output L.E.D. Indicators E.D. Display Indicators DOTPhase 5 DMC Computer Input and Output L.E.D. Indicators WR ADC450162 1- 10/15/98-50