Homelite UT80953 Packing List, Tools Needed, Attaching the Wheel Assembly, Installing the Handle

Page 12

ASSEMBLY

PACKING LIST

Pressure Washer

25 ft. High Pressure Hose Trigger Handle

Spray Wand Quick-connect Nozzles (4) Injection Hose Injection Hose Filter Upper Spray Wand Holder Lower Spray Wand Holder Lock Nut

M8 10 mm Bolt

M8 13 mm Flange Nut

4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)) Axle (2)

Hitch pins (2) Wheels (2) Washers (2) Handle Operator’s Manual

TOOLS NEEDED

See Figure 1a.

n13 mm Socket Wrench (9/16 in.)

n10 mm Wrench (7/16 in.)

WARNING:

If any parts are damaged or missing do not operate this tool until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.

WARNING:

Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.

WARNING:

To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.

ATTACHING THE WHEEL ASSEMBLY

See Figure 2.

nLocate the axle, hitch pins, washers, and wheels.

nSlide the axle through the hole in the center of the wheel.

nSlide the washer onto the axle.

nLift the machine and slide the axle into the wheel mount- ing hole in the machine base as shown.

nPush the hitch pin into the hole on the end of the axle to secure the wheel assembly.

NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle.

nRepeat with the second wheel.

INSTALLING THE HANDLE

See Figure 3.

Push and hold the push-pin button on the side of the handle as you slide the handle onto the frame.

NOTE: Before use, pull the handle up until the lock button snaps through the locking slots to secure the handle in place.

INSTALLING THE UPPER AND LOWER SPRAY WAND HOLDER

See Figure 4.

nAlign upper spray wand holder with holes in handle, as shown.

nSlide long side of spray wand holder through handle and tighten securely with lock nut.

nPlace lower spray wand holder over the holes.

nAlign the bolt with the holes and push the bolt through.

nHold flange nut with 13 mm wrench and bolt head with 10 mm socket. Tighten until the bolt is snug.

ASSEMBLING THE TRIGGER HANDLE

See Figure 5.

nPlace the threaded end of the spray wand in the connector on the end of the trigger handle.

nTurn the connector clockwise until it stops. This secures the spray wand in place.

CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE

See Figure 6.

nScrew the collar on the high pressure hose into the trigger handle inlet coupler by turning the hose collar clockwise.

nPull on the hose to be certain it is properly secured.

ATTACHING INJECTION HOSE

See Figure 7.

Before detergent can be used with this machine, the injection hose must be attached.

nPush the injection hose filter onto the end of the injection hose (if not already installed).

nPush the open end of the clear injection hose securely over the fitting.

NOTE: Keep injection hose away from hot surfaces.

Page 8 — English

Image 12
Contents PSI Pressure Washer Save this Manual for Future ReferenceCombustible Interruptor del motor Del gatillo Iii Funnel entonnoir, embudo Page Table of Contents IntroductionImportant Safety Instructions Read ALL Instructions3 English Specific Safety Rules 4 EnglishSymbols 5 English6 English Features AssemblyAttaching the Wheel Assembly Installing the HandleInstalling the Upper and Lower Spray Wand Holder Connecting High Pressure Hose to Trigger HandleConnecting the High Pressure Hose to the Pump Connecting the Garden Hose to the Pressure WasherOperation ApplicationsADDING/CHECKING Engine Lubricant Oxygenated FuelsAdding Gasoline to the Fuel Tank Pump LubricantUsing the Spray Wand Trigger Using the High Pressure HoseSelecting the Right Nozzle for the JOB See FiguresMaintenance General MaintenanceWashing with Detergent Rinsing with the Pressure WasherNozzle Maintenance CLEANING/REPLACING the AIR FilterPump Maintenance Changing Engine LubricantPeriodic Maintenance Schedule Table Preparing for USE After Storage14 English Troubleshooting Problem Cause Solution15 English Warranty Limited NON Engine Warranty Statement16 English 17 English Emission Related Parts Include the FollowingInstructions Importantes Concernant LA Sécurité AVERTISSEMENT Lire Toutes LES Instructions 3 FrançaisRègles DE Sécurité Particulières 4 FrançaisSymboles Symbole Signal Signification5 Français Avertissement 6 FrançaisCaractéristiques AssemblageInstallation DES Roues Installation DU MancheListe DE Contrôle Outils NécessairesInstallation DU Tuyau D’INJECTION UtilisationConnexion DU Flexible Haute Pression SUR LA Pompe Connexion DU Tuyau D’ARROSAGE AU Nettoyeur Haute PressionAJOUT/VÉRIFICATION DE Lubrifiant Carburants OxygénésAppoint D’ESSENCE Huile DE LA PompeFonctionnement Poignée DE Gâchette Utilisation DU Tuyau Haute PressionVoir les figures 11 FrançaisEntretien NETOYAGE/ Remplacement DU Filtre À AIR Entretien DE BuseVidange DE LE Lubrifiant Moteur Entretien DE LA BougieRemise EN Service Après Remisage Tableau DE Calendrier D’ENTRETIEN Périodique14 Français Problème Cause Solution Dépannage15 Français Garantie Énoncé DE LA Garantie Limitée Hors Moteur16 Français 17 Français Parmi LES Pièces Liées AUX ÉMISSIONS, on RetrouveInstrucciones Importantes DE Seguridad AdvertenciaLEA Todas LAS Instrucciones Página 3 Español Siempre reabastezca el combustible al aire libre. Nunca Página 4 EspañolSímbolos PeligroPrecaución Página 5 EspañolPágina 6 Español Características ArmadoLista DE Empaquetado Herramientas NecesariasMontaje DEL Conjunto DE LAS Ruedas Instalación DEL MangoFuncionamiento Cómo Conectar LA Manguera DE InyecciónCómo Conectar LA Manguera DE Alta Presión a LA Bomba Paraconectar una manguera de jardín a la máquinaUsos Abastecimiento Y Verificación DE LubricanteAbastecimiento DEL Tanque DE Gasolina Lubricante Para BombaUSO DE LA Manguera DE Alta Presión USO DEL Mango DEL GatilloVea las figuras Página 11 EspañolMantenimiento Enjuagado CON LA Lavadora DE PresiónTraslado DE LA Lavadora DE Presión Mantenimiento GeneralMantenimiento DE LAS Boquillas Limpieza DEL Filtro DE AireCambio DEL Lubricante DEL Motor Mantenimiento DE LA BujíaTabla DEL Programa Periódico DE Mantenimiento Página 14 EspañolSolución DE Problemas Problema Causa SoluciónPágina 15 Español Garantía Declaración DE Garantía Limitada no Aplicable AL MotorPágina 16 Español Página 17 Español OPERATOR’S Manual Manuel D’UTILISATION Manual DEL OperadorUT80522 / UT80953 Model no Serial no Numéro DE Série