Enginemaintenance, Ell, CheckingOil Level

Craftsman 580.75213 manual Enginemaintenance, Ell, WidENTESTINGFORENGINESPARE, CheckingOil Level

ENGINEMAINTENANCE

WARNING

Unintentional sparking can result in fire or

_¢ electric shock.

WHENADJUSTINGORMAKINGREPAIRSTO YOUR PRESSUREWASHER

*Disconnectthe sparkplugwire fromthe sparkplugandplace the wire whereit cannotcontactsparkplug.

WidENTESTINGFORENGINESPARE

*Useapprovedsparkplugtester.

o DONOTcheckfor sparkwith sparkplugrernoved.

ell

eli Recommendations

NOTE:Usea high quality detergent oii classified "For Service SF,SG, SH, SJ" or higher. DO NOTuse special additives.

1= Choosea viscosity according to the tabb below:

CheckingOil Level

OiI level should be checked prior to each use or at least every 5 hours of operation. Keepoii ievei maintained.

1.Makesure pressure washer is on a ievei surface=

2= Remove oii dipstick and wipe dipstick with clean cioth= Reptaceand tigilten dipstick. Removeand and check oil levei.

3.Verify oii is at "FuIF mark on dipstick. Replaceand tigilten dipstick.

Adding EngineOil

1= Makesure pressure washer is on a Ieveisurface.

2.Checkoii ievei as described in Checking Off Level

3.If needed,siowiy pour oil into oil fiii openingto the "Full" mark on dipstick. DO NOToverfill.

86	o	30
68		20
		40 C
50		10
32	.(.3	--
32
104 F r_
14		-10
4		-20
-22		-30

NOTE:Synthetic oii meeting iLSAC GF=2,API certification markand APi service symboi with "SJ/CF ENERGY CONSERVING"or higher, is an acceptable oii at aii temperatures. Useof synthetic oil does not alter required oil change intervals.

SAE30: 40°Fand higher (5°C and higher) is good for aii purpose use above 40%, use below 40°F will cause hard starting.

18W-30:0 to IO0°F (=18to 38°C) is better for varying temperature conditions. This viscosity improves cold weather starting, but may increase oil consumption above 80% (27%).

*Check oii bvet frequently at higiler temperatures.

Synthetic 5W-30:=20 to 120°F(=30to 40 °C) provides the best protection at ali temperatures as weil as improved starting with iess oii consumption=

5W-30: 40°F and below (5°C and be/'ow)is recommendedfor winter use and works best in cold conditions=

Overfilling with oil may causethe engineto not start, or hard starting.

DONOToverfill.

Ifoverthe FULLmarkon dipstick,drainoffto reduceoil levelto FULLmarkon dipstick.

4.Replaceand tigllten dipstick.

ChangingEngineOil

Changeengine oii after the first 5 hours and every 50 hours thereafter, if you are using your pressure washer under extremeiy dirty or dusty conditions, or in extremely hot weather, change oil more often.

CAUTION

Avoid prolonged or repeatedskin contact with used motor oil.

Usedmotoroil hasbeenshownto causeskincancer[ncertain laboratoryanimals Thoroughlywashexposedareaswith soapandwater

KEEPOUTOF REACHOF CHILDREN.DON'T POLLUTE.CONSERVERESOURCESRETURN. USEDOIL TO COLLECTIONCENTERS.

Change eli while engine is still warm from running, as follows:

1.Drain fuel tank by running pressurewasher until fuel tank is empty.

2.Disconnect spark plug wire and keep it awayfrom spark plug.