5A | Garden hose |
|
Figure 6 - Connect the remaining portion of the adapter (M1) to the water (INLET)
(B)of the cleaner as shown. The intake water temperature must NOT exceed 50°C (122°F). The water supply pressure must NOT exceed 10 bar (145psi).
CAUTION: The pressure washer must only be used with clean water; use of unfiltered water or corrosive chemicals will damage the pressure washer.
6
Figure 7 - With the adapter (M2) attached to your water hose, pull back on the top section and push onto the water inlet (B) of the pressure washer then release.
7
Figure 8 - Connect garden hose to the cold water source and turn water on full.
8
OPERATION
NOTE: Before cleaning any surface, an inconspicuous area should be cleaned to test spray pattern and distance for maximum cleaning results. If painted surfaces are peeling or chipping, use extreme caution as pressure washer may remove the loose paint from the surface.
The PW1500 Pressure Washer is equipped with automatic delivery flow cut- off:
When the trigger is released, the dynamic pressure automatically cuts out the motor.
When the trigger is pressed the pressure drop automatically starts the motor and the pressure is restored with a very slight delay.
Figure 9 - Plug the Ground Fault
Circuit Interrupter (GFCI) (I) into a working grounded outlet. TEST BEFORE EACH USE. The indicator at the top of the GFCI should turn red when product is ready to use. Press the “TEST” button (bottom). The red indicator should disappear. Press “RESET” button for use. Do not use if the above test fails.
9
Figure 10 - Release the safety catch shown in Figure 10, then press the trigger for a few seconds to allow air to escape and to discharge residual pressure in the hoses.
10 |
5