Briggs & Stratton 10KW, 12KW owner manual Before Initial START-UP, Engine Oil, Battery Connection

Page 12

Briggs & Stratton Power Products Home Generator

Owners Manual

BEFORE INITIAL START-UP

Engine Oil

This engine is shipped from the factory filled with the recommended oil. Before starting the engine, check oil level and ensure that engine is serviced as described in the engine owner’s manual.

CAUTION

Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure.

•Refer to engine manual for oil fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

Oil Considerations

Your Home Standby Generator is equipped with an engine that has been pre-run at the factory and does not require the traditional “break-in” procedure.

Battery Connection

The Home Standby Generator is supplied with a 12 Volt DC 33 Amp-Hour battery. It is a sealed, lead-acid rechargeable battery. It is installed in the unit and the battery cables are connected at the factory.The unit’s

15 Amp fuse, which isolates the battery and prevents the unit from starting, has been removed for shipping.

CAUTION

Installing the 15A fuse could cause the engine to start.

•DO NOT install the 15 Amp fuse until all plumbing and wiring has been completed and inspected.

NOTE: With the battery installed, all wiring to transfer switch and Home Standby Generator completed, utility power supplied to the Automatic Transfer Switch, and the unit in AUTO mode, the battery receives a trickle charge while the engine is not running.The trickle charger cannot be used to recharge a battery that is completely discharged.

The system is filled with synthetic oil (API SJ/CF 5W-30W). This allows for system operation in the widest range of temperature and climate conditions.

NOTE: The use of synthetic oil DOES NOT alter the required oil change intervals described in the engine owner’s manual.

Gaseous Fuel System

•Ensure that all fuel connections are tight, secure and without leaks.

WARNING

Propane and Natural Gas is extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

•DO NOT operate engine if smell of fuel is present or other explosive conditions exist.

•If you smell ‘raw’ gaseous fuel (natural or LP) near the unit, immediately turn off the gas supply to the Home Standby Generator.

•Contact your gas utility or the system installer for assistance in determining the source of the smell.

•Ensure that all shutoff valves are OPEN and that adequate pressure is available (see installation manual).

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Manual del Propietario Manuel de lUtilisateur Table of Contents Safety Rules Briggs & Stratton Power Products Home Generator Approved Transfer Switches Installation AssistanceIntroduction Owner OrientationPower Decrease at High Altitude or High Temperature Fuel FactorsGenerator Location Generator ClearancesEssential Circuits Essential Circuit SelectionDevice Running Watts Shipment Contents UnpackingDelivery Inspection Know Your Home Standby Generator Know Your System Control Panel LEDAccess Doors To Remove an Access DoorTo Install an Access Door Battery Connection Before Initial START-UPEngine Oil Gaseous Fuel SystemSetting Exercise Timer To perform the Set Exercise procedureAutomatic Operation Servicing the SystemSpecifications Fault Detection SystemGenerator Low Battery Voltage Oil Temperature HighLow Oil Pressure Engine Fail To StartGenerator Maintenance To Clean the GeneratorWhen Calling the Factory StorageTroubleshooting Problem Cause CorrectionTabla DE Contenido Manual del PropietarioInstrucciones DE Seguridad PeligroAdvertencia Precaución Introducción Orientación Para EL PropietarioConmutadores de Transferencia Aprobados Asistencia para la instalaciónFactores Relacionados con el Combustible Ubicación del GeneradorDistancias Desde el Generador Circuitos Fundamentales Selección de los Circuitos FundamentalesDispositivo Vatiaje de Desempaque Inspección al Momento de la EntregaContenido de la Caja El Generador Doméstico incluye lo siguienteConozca SU Generador Doméstico DE Reserva Conozca EL Panel DE Control DEL Sistema Puertas de Acceso Para Retirar una Puerta de AccesoPara Instalar una Puerta de Acceso Antes DEL Arranque Inicial Conexión de la BateríaAceite de Motor Sistema de Combustible GaseosoConfiguración del Temporizador de Práctica Operación AutomáticaVerificación de la Operación Automática Paro del SistemaEspecificaciones MantenimientoGenerador Baja Tensión de la Batería Baja Presión de AceiteBaja Tensión El Motor no ArrancaSobrevelocidad del Motor Alta Temperatura del AceiteMantenimiento DEL Generador AlmacenamientoCambio del Aceite del Motor Para Limpiar el GeneradorNotas Reparacion DE Averias Table DES Matières Manuel dUtilisationRègles DE Sécurité AvertissementLe contact de ces pièces risque de causer de graves brûlures Aide à lInstallation IntroductionConseils AU Propriétaire Commutateurs de Transfert ApprouvésEmplacement de la Génératrice Facteurs Relatifs au CombustibleDégagement Autour de la Génératrice Circuits Essentiels Sélection des Circuits EssentielsAppareil Watts Déballage Vérification de la LivraisonContenu de la Boîte Le Groupe Électrogène est Livré avec les Éléments SuivantsFAMILIARISEZ-VOUS Avec Votre Groupe Électrogène La position normale de fonctionnement est la position Pour Installer une Porte dAccès Portes dAccèsPour Enlever une Porte dAccès Avant LE Démarrage Initial Branchement de la BatterieHuile à Moteur Système de Combustible GazeuxFonctionnement Automatique Arrêt du SystèmeVérification du Fonctionnement Automatique Réglage de la Minuterie du Cycle dExerciceCaractéristiques EntretienGénératrice Faible Tension de la Batterie Faible Pression dHuileBasse Tension Le Moteur Ne Démarre PasEmballement du Moteur Température de lHuile ÉlevéeEntretien DU Générateur RemisagePour Nettoyer le Générateur Vidange de lHuile MoteurDépannage
Top Page Image Contents