Briggs & Stratton 01938-0 manual Access Doors, Insert, Battery, Control

Briggs & Stratton Power Products Home Generator

Installation Manual

Figure 3 — Location of Lifting Holes

To lift:
Insert
pipe
here	Installer-supplied pipe

CAUTION! The unit may shift on the lifting pipes during movement, which may cause injury.

WARNING! If lifting or hoisting equipment is used, be careful not to touch any overhead power lines.

You may also lift the unit using a “hook and hoist” method attached to the lifting pipes, provided that you use a spreader bar to ensure that the chains or cables do not touch the generator’s roof.

Retouch any chipped paint with supplied touch-up paint. After paint is dry, and the unit is in place, fill the lifting holes with the supplied lifting hole plugs.

Access Doors

The Home Standby Generator is equipped with an enclosure that has four access doors (Figure 4).The doors are named for a significant component located behind them. Starting with the side that has the fuel connection and proceeding clockwise, the doors are named:

•Oil Service door

•Air Intake door

•Control Panel door

•Battery door

Each Home Standby Generator is equipped with three identical keys.These keys fit the locks that secure the Oil Service and Control Panel doors.

CAUTION

DO NOT operate the Home Standby Generator unless the Oil Service and/or Control Panel doors are installed.

•Failure to install Oil Service and/or Control Panel doors while operating the Home Standby Generator will cause overheating.

Figure 4 — Enclosure Access Doors

Door Lock						Exhaust
Screw						Port
						Fuel
						Inlet				29”
						Door
						Lock
						Screw
Air			42”		Door	Battery			Panel	Door
	Intake
				Service			Door
		30”						Control
		Door
			Oil
						6