SBC MC8650_EXPLODED DIGRAM_3
SBC BC8650_ENGLISH_4
SBC MC8650_ENGLISH_5
4ENGLISH
FM Wireless Microphone
SBC MC 8650
Congratulations! You have just bought the best RF/FM wireless microphone system. Philips uses the latest RF/FM wireless technology to give you complete freedom of movement. No more inconvenient cables and wires!
Legend of Product illustration on inside flap:
ENGLISH 5
Contents of Box
Your system consists of the following accessories:
1 x SBC MC8652 microphone,
1 x SBC MC8655 microphone receiver
1 x SBC CS030/00 12Volt/200mA adapter (for UK version: SBC CS030/05) 1 x mono audio cable (1m)
1 x 9 Volt battery 6LR61 type, SM544
1 x 3.5mm to 6.3mm mono adapter plug
PHILIPS
SBC MC8652
1
POWER
ON
2
|
| DIGIT | |
|
| AL T | |
|
| UN | |
|
| ING | |
|
| SBC | |
|
| MC8655 | |
|
| B | |
|
| . | |
| CH.A | CH | |
3 | OFF | ||
|
FM Microphone
1Power ON and battery indicator – Indicator: starts blinking if battery level is low. You should then replace the battery.
2Power ON/OFF
3Channel selection (CH A/CH B)
FM Microphone Receiver
4Power ON/OFF and Channel selection (CH A/CH B)
5Power ON indicator
6Microphone signal output
7DC Power input
| MIC |
DC12V | OUT |
Installation
Receiver Power Supply
1Insert the DC connector of the AC/DC adapter into the 12 Volt DC input of the FM microphone receiver. Always ensure adapter’s rated voltage corresponds to the mains socket voltage.
CH.B | PHILIPS | .A | 4 |
| |||
| CH |
Important
2Connect the adapter to the mains supply.
5
- + 
Read these instructions: All the safety and operating instructions should be read before using the wireless microphone system.
• Check if the voltage indicated on the type plate of the adapter |
corresponds to the local mains voltage before connecting to the |
mains power supply. |
• Always switch the FM microphone and the receiver to the OFF |
position when not in use to save energy. |
• Remove the battery from the compartment and disconnect the |
adapter from the mains if the system is not in use for long period. |
• Batteries contain chemical substances, so they should be disposed |
| MIC |
DC12V | OUT |
|
ø3.5MM
MONO JACK
3
HIFI/
KARAOKE
SET
Note: - Only use Philips SBC CS030/00 12Volt/200mA AC/DC adapter (For UK, use only Philips SBC CS030/05)
- Always disconnect the adapter when you are not using it.
Audio Connections
Insert the audio cable to the microphone receiver output and connect to the microphone input of your HiFi or karaoke system.
>In case your audio source has a 6.3mm microphone input, connect the 3.5mm to 6.3mm mono adapter plug, which is supplied with the set.
properly. |
• Prevent fire or shock hazard: do not expose this equipment to |
humidity, rain, sand or excessive heat caused by heating equipment |
or direct sunlight. |
• Use a slightly dampened chamois cloth to clean the housing. Do |
not use cleaning agents containing alcohol, spirits, ammonia or |
Microphone Power Supply
- | + |
| 4 Insert a 9Volt battery into the FM microphone battery compartment, with the |
| correct polarity as shown. |
6
| MIC | |
DC12V | OUT | |
7 | ||
|
FM Microphone | FM Microphone Receiver |
abrasives as these may harm the housing. |
• Radio equipment for wireless audio applications is not protected |
against disturbance from other radio services. |
.B H C
OFF
| .A |
C | H |
.A H C
.B H C
Channel Selection
5Select the same channel in the microphone and the receiver. The preset channel is Channel A.
Note: When using 2 FM wireless microphones in the same room, switch one of the microphone set to Channel B.