Xerox 3250 Using the manual feeder, Load the paper with the side to be printed on facing up

Notes

• Do not push the paper width guide far enough to cause the material to warp.

•If you do not adjust the paper width guide, it may cause paper jams.

Using the manual feeder

You can manually load a sheet of print media in the manual tray if you select Manual Feeder in the Source option from the Paper tab when you change print settings to print a document. See the Software Section.

Manually loading paper can be helpful when you want to check the print quality after each page is printed.

Load paper sheet-by-sheet in the manual tray, send print data to print the first page, and press the Start/Stop button on the control panel to print each following page.

1Open the manual feed door.

3250-024

2 Load the paper with the side to be printed on facing up.

3250-025

3Adjust the manual tray paper width guides to the width of the paper. Do not force too much, or the paper will bend, which could result in a paper jam or skew.

3250-026

4When you print a document, set the paper source to Manual Feeder and select the appropriate paper size and type in the software application. See the Software Section.

5Print a document.

6Press the Start/Stop button. The printer feeds the next sheet.

Note

• If you do not press the Start/Stop button, after a pause the printer will automatically feed the print media.

7Insert the next sheet into the manual tray and press the Start/Stop button.

Repeat this step for every page to be printed.

5.6 <Loading print media>