Cisco Systems ONS 15600 SDH manual DLP-F333 Install the Asap Carrier Modules, 18-33

Chapter 18 DLPs F300 to F399

DLP- F333 Install the ASAP Carrier Modules

Step 10 Return to your originating procedure (NTP).

DLP-F333 Install the ASAP Carrier Modules

Purpose	This procedure explains how to install the carrier modules in the
	ONS 15600 SDH shelf.
Tools/Equipment	ASAP carrier modules
Prerequisite Procedures	NTP-F118 Install the Common Control Cards, page 2-2
Required/As Needed	As needed
Onsite/Remote	Onsite
Security Level	None

Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the midplane with your hand or any metal tool, or you could shock yourself. Statement 181

Caution Always use the supplied ESD wristband when working with a powered ONS 15600 SDH. Plug the wristband cable into the ESD jack located on the lower-left outside edge of the shelf.

Warning Class 1 laser product. Statement 1008

Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not view directly with optical instruments. Viewing the laser output with certain optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard. Statement 1056

Warning Use of controls, adjustments, or performing procedures other than those specified may result in hazardous radiation exposure. Statement 1057

Note For information about the ASAP card, refer to the Cisco ONS 15600 SDH Reference Manual.

Step 1 Remove the carrier module from the box and antistatic sleeve.

Caution Setting an ASAP carrier module on its connectors can cause damage to the connectors.

Step 2 Slide the module along the top and bottom guide rails into the correct slot: Slots 1 to 4 and 11 to 14 are available for traffic cards. Insert the card until it contacts the backplane.

Step 3 Close the ejectors.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-33