Cisco Systems ONS 15600 SDH manual DLP-F360 Delete a PPM, 18-72

Chapter 18 DLPs F300 to F399

DLP- F360 Delete a PPM

Step 6 Click Yes in the Confirm Port Rate Change dialog box.

Step 7 Return to your originating procedure (NTP).

DLP-F360 Delete a PPM

Purpose	This task deletes PPM provisioning for SFPs/XFPs on the ASAP card.
Tools/Equipment	None
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 Determine if you can delete the PPM. You cannot delete a port on a PPM if it is in service, part of a protection group, has a communications channel termination in use, is a timing source, has circuits, or has overhead circuits. As needed, complete the following procedures and task:

•NTP-F204 Modify or Delete Optical 1+1 Port Protection Settings, page 11-4

•NTP-F205 Change Node Timing, page 11-5

•NTP-F209 Modify or Delete Communications Channel Terminations, page 11-8

•NTP-F177 Modify and Delete Circuits, page 7-2

•NTP-F178 Modify and Delete Overhead Circuits and Server Trails, page 7-3

•DLP-F254 Change the Service State for a Port, page 17-47

Step 2 In node view, double-click the ASAP card where you want to delete PPM settings.

Step 3 Click the Provisioning > Pluggable Port Modules tabs.

Step 4 To delete a PPM and the associated ports:

a.Click the PPM line that appears in the Pluggable Port Modules area. The highlight changes to dark blue.

b.Click Delete. The Delete PPM dialog box appears.

c.Click Yes. The PPM provisioning is removed from the Pluggable Port Modules area and the Pluggable Ports area.

Step 5 Verify that the PPM provisioning is deleted:

•If the PPM was preprovisioned, CTC shows an empty slot in CTC after it is deleted.

•If the SFP/XFP, 1PIO, or 4PIO (PIM) is physically present when you delete the PPM provisioning, CTC transitions to the deleted state, the ports (if any) are deleted, and the PPM is represented as a gray graphic in CTC. The SFP/XFP or PIM can be provisioned again in CTC, or the equipment can be removed, in which case the removal causes the graphic to disappear.

Step 6 If you need to remove the SFP/XFP, see the “DLP-F388 Remove an SFP/XFP” procedure on page 18-101. If you need to remove the 1PIO or 4PIO where the SFP/XFP is installed, see the “DLP-F389 Remove a 1PIO or 4PIO (PIM) Module” procedure on page 18-102.”

	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-72	October 2007