Cisco Systems ONS 15600 SDH manual DLP-F365 Add a Tarp Manual Adjacency Table Entry, 18-77

Chapter 18 DLPs F300 to F399

DLP- F364 Remove a Static TID-to-NSAP Entry from the TARP Data Cache

DLP-F364 Remove a Static TID-to-NSAP Entry from the TARP Data Cache

	Purpose	This task removes a static TID-to-NSAP entry from the TDC.
	Tools/Equipment	None
	Prerequisite procedures	DLP-F181 Log into CTC, page 16-34
	Required/As needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioner or higher
Step 1	In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 2	Click the static entry that you want to delete.
Step 3	Click Delete Static Entry.
Step 4	In the Delete TDC Entry dialog box, click Yes.
Step 5	Return to your originating procedure (NTP).

DLP-F365 Add a TARP Manual Adjacency Table Entry

	Purpose	This task adds an entry to the TARP manual adjacency table (MAT). Entries
		are added to the MAT when the ONS 15600 SDH must communicate across
		routers or non-SDH NEs that lack TARP capability.
	Tools/Equipment	None
	Prerequisite procedures	DLP-F181 Log into CTC, page 16-34
	Required/As needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioning or higher
Step 1	In the node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 2	Click Add.
Step 3	In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:

•Level—Sets the TARP Type Code that will be sent:

–Level 1—Indicates that the adjacency is within the same area as the current node. The entry generates Type 1 PDUs.

–Level 2—Indicates that the adjacency is in a different area than the current node. The entry generates Type 2 PDUs.

•NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter the address in the Masked NSAP Entry dialog box.

Step 4 Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static Entry dialog box.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-77