Cisco Systems ONS 15600 SDH manual DLP-F304 Repair an IP Tunnel, 18-4

Chapter 18 DLPs F300 to F399

DLP- F304 Repair an IP Tunnel

DLP-F304 Repair an IP Tunnel

Purpose	This task repairs circuits that are in the PARTIAL status as a result of node
	IP address changes.
Tools/Equipment	None
Prerequisite Procedures	See Chapter 6, “Create Circuits.” for circuit creation procedures.
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 Obtain the original IP address of the node in question.

Step 2 From the View menu, choose Go to Network View.

Step 3 From the Tools menu, choose Overhead Circuits > Repair IP Circuits.

Step 4 Review the text in the IP Repair wizard and click Next.

Step 5 In the Node IP address area, complete the following:

•Node—Choose the node that has a PARTIAL circuit.

•Old IP Address—Type the node’s original IP address.

Step 6	Click Next.
Step 7	Click Finish.
Step 8	Return to your originating procedure (NTP).

DLP-F305 Provision Path Trace on Circuit Source and Destination Ports

		Purpose	This task creates a path trace on VC circuit source ports and destination.
		Tools/Equipment	ONS 15600 SDH cards capable of transmitting and receiving path trace
			must be installed at the circuit source and destination ports. See Table 18-1
			for a list of cards.
		Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
		Required/As Needed	As needed
		Onsite/Remote	Onsite or remote
		Security Level	Provisioning or higher
	Note	This task assumes you are setting up path trace on a bidirectional circuit and setting up transmit strings
		at the circuit source and destination.
	Step 1	From the View menu, choose Go to Network View.
	Step 2	Click the Circuits tab.
	Step 3	For the VC circuit you want to monitor, verify that the source and destination ports are on a card that can
		transmit and receive the path trace string. Table 18-1provides a list of cards that support path trace.
	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-4			October 2007