Chapter 18 DLPs F300 to F399
DLP- F339 Create a Two-Fiber MS-SPRing Manually
•On the network view graphic, a green span line appears between all MS-SPRing nodes.
•All E-W-MISMATCH, RING-MISMATCH, APSCIMP, APSCDFLTK, and MSSP-OOSYNC alarms are cleared. See the Cisco ONS 15600 SDH Troubleshooting Guide for alarm troubleshooting procedures.
Note The numbers in parentheses after the node name are the MS-SPRing node IDs assigned by CTC. Every ONS 15600 SDH in an MS-SPRing is given a unique node ID, 0 through 31. To change it, complete the “DLP-F340 Change an MS-SPRing Node ID” task on page 18-41.
Step 9 Return to your originating procedure (NTP).
DLP-F339 Create a Two-Fiber MS-SPRing Manually
| Purpose | This tasks creates a two-fiber MS-SPRing at each MS-SPRing-provisioned |
| | node without using the MS-SPRing wizard. |
| Tools/Equipment | None |
| Prerequisite Procedures | NTP-F147 Provision MS-SPRing Nodes, page 5-6 |
| | DLP-F181 Log into CTC, page 16-34 |
| Required/As Needed | Required |
| Onsite/Remote | Onsite or remote |
| Security Level | Provisioning or higher |
| |
Step 1 | In node view, click the Provisioning > MS-SPRingtabs. |
Step 2 | Click Create. | |
Step 3 | In the Suggestion dialog box, click OK. |
Step 4 | In the Create MS-SPRing dialog box, set the MS-SPRing properties: |
•Ring Type—Choose two-fiber.
•Ring Name—Assign a ring name. You must use the same ring name for each node in the MS-SPRing. Any alphanumeric character string is permissible, and uppercase and lowercase letters can be combined. Do not use the character string All in either uppercase or lowercase letters; this is a TL1 keyword and will be rejected. Do not choose a name that is already assigned to another MS-SPRing.
•Node ID—Choose a Node ID from the drop-down list (0 through 31). The Node ID identifies the node to the MS-SPRing. Nodes in the same MS-SPRing must have unique Node IDs.
•Reversion time—Set the amount of time that will pass before the traffic reverts to the original working path. The default is 5 minutes. All nodes in a MS-SPRing must have the same reversion time setting.
•West Line—Assign the west MS-SPRing port for the node from the drop-down list.
Note The east and west ports must match the fiber connections and DCC terminations set up in the “NTP-F147 Provision MS-SPRing Nodes” procedure on page 5-6.
| Cisco ONS 15600 SDH Procedure Guide, R8.0 |
18-40 | October 2007 |
