Cisco Systems ONS 15600 SDH manual Click the Circuits tab, 18-62

Chapter 18 DLPs F300 to F399

DLP- F353 Roll Two Cross-Connects on One Optical Circuit Using Automatic Routing

Step 12 If you selected Manual in Step 5, click the roll on the Rolls tab and click Complete to route the traffic to the new port. If you selected Auto, continue with Step 13.

Step 13 For both manual and automatic rolls, click Finish to complete the circuit roll process.

The roll is cleared from the Rolls tab and the new rolled circuit on Circuits tab returns to the

DISCOVERED status.

Step 14 Return to your originating procedure (NTP).

DLP-F353 Roll Two Cross-Connects on One Optical Circuit Using Automatic Routing

Purpose	This task reroutes the network path while maintaining the same source and
	destination. This task allows CTC to automatically select a Roll To path.
Tools/Equipment	None
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Note This task optionally uses automatic routing. Automatic routing is not available if both the Automatic Circuit Routing NE default and the Network Circuit Automatic Routing Overridable NE default are set to FALSE. For a full description of these defaults see Appendix C, “Network Element Defaults,” in the Cisco ONS 15600 SDH Reference Manual.

Step 1 From the View menu, choose Go To Network View.

Step 2 Click the Circuits tab.

Step 3 Click the circuit that has the connections that you want to roll. The circuit must have a DISCOVERED status for you to start a roll.

Step 4 From the Tools menu, choose Circuits > Roll Circuit.

Step 5 In the Roll Attributes area, complete the following (Figure 18-17):

a.From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll or Manual to create a manual roll.

b.From the Circuit Type drop-down list, choose Dual to indicate that you want to roll two connections on the chosen circuit.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-62	October 2007