Cisco Systems ONS 15600 SDH manual DLP-F336 Print CTC Data, 18-36

Chapter 18 DLPs F300 to F399

DLP- F336 Print CTC Data

Note Only the parameters that are editable for the PPMs on a particular platform type are provisionable. For example, some platforms may not have PPMs with configurable wavelengths or reaches. In this case, wavelength and reach are not provisionable.

Step 10 Repeat Steps 1 to 10 create a second PPM.

Step 11 Click OK.

Step 12 When you are ready to install the SFP, complete the “DLP-F387 Install an SFP/XFP” task on page 18-100.

Step 13 Return to your originating procedure (NTP).

DLP-F336 Print CTC Data

Purpose	This task prints CTC windows and CTC table data such as alarms and
	inventory.
Equipment/Tools	A printer must be connected to the CTC computer
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Retrieve or higher

Step 1 From the CTC File menu, click Print.

Step 2 In the Print dialog box (Figure 18-9), choose an option:

•Entire Frame—Prints the entire CTC window including the graphical view of the card, node, or network.

•Tabbed View—Prints the lower half of the CTC window.

•Table Contents—Prints CTC data in table format; this option is only available for CTC table data (see Table A-6 on page A-10). It does not apply to:

•Provisioning > General window

•Provisioning > SNMP window

•Provisioning > Timing window

•Provisioning > Network > Internal Subnet window

•Provisioning > Network > General window

•Provisioning > Security > Policy window

•Provisioning > Security > Access window

•Provisioning > Security > Legal Disclaimer window

•Provisioning > OSI > Main Setup window

•Provisioning > OSI > TARP > Config window

•Maintenance > Database window

	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-36	October 2007