Cisco Systems ONS 15600 SDH manual DLP-F373 Edit the OSI Subnetwork Point of Attachment, 18-84

Chapter 18 DLPs F300 to F399

DLP- F373 Edit the OSI Subnetwork Point of Attachment

DLP-F373 Edit the OSI Subnetwork Point of Attachment

Purpose	This task allows you to view and edit the OSI subnetwork point of
	attachment parameters. The parameters are initially provisioned when you
	create a regenerator section DCC (RS-DCC) or multiplex section DCC
	(MS-DCC), or when you enable the LAN subnet.
Tools/Equipment	None
Prerequisite procedures	DLP-F181 Log into CTC, page 16-34
Required/As needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 In the node view, click the Provisioning > OSI > Routers > Subnet tabs.

Step 2 Choose the subnet you want to edit, then click Edit.

Step 3 In the Edit subnet type Subnet slot/port dialog box, edit the following fields:

•ESH—The End System Hello PDU propagation frequency. The field is not used by the ONS 15600 SDH.

•ISH—The Intermediate System Hello PDU propagation frequency. An intermediate system NE sends ISHs to other ESs and ISs to inform them about the NETs it serves. The default is 10 seconds. The range is 10 to 1000 seconds.

•IIH—The Intermediate System to Intermediate System Hello PDU propagation frequency. The IS-IS Hello PDUs establish and maintain adjacencies between ISs. The default is 3 seconds. The range is 1 to 600 seconds.

Note The IS-IS Cost and DIS Priority parameters are provisioned when you create or enable a subnet. You cannot change the parameters after the subnet is created. To change the DIS Priority and IS-IS Cost parameters, delete the subnet and create a new one.

Click OK.

Step 4 Return to your originating procedure (NTP).

DLP-F374 Edit an IP-Over-CLNS Tunnel

	Purpose	This task allows you to edit the parameters of an IP-over-CLNS tunnel.
	Tools/Equipment	None
	Prerequisite procedures	DLP-F369	Create an IP-Over-CLNS Tunnel, page 18-80
		DLP-F181	Log into CTC, page 16-34
	Required/As needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioning or higher
	Cisco ONS 15600 SDH Procedure Guide, R8.0
18-84			October 2007