Chapter 18 DLPs F300 to F399
DLP- F350 Delete an
Step 4 Return to your originating procedure (NTP).
DLP-F350 Delete an MS-SPRing from a Single Node
Purpose | This task deletes an |
| from the |
Tools/Equipment | None |
Prerequisite Procedures | |
Required/As Needed | As needed |
Onsite/Remote | Onsite or remote |
Security Level | Provisioning or higher |
Step 1 In node view, display the node that was removed from the
•If the node that was removed is connected to the same LAN as your computer, from the File menu, choose Add Node, then enter the node name or IP address.
•If the node that was removed is not connected to the same LAN as your computer, you must connect to the node using a direct connection. See Chapter 3, “Connect the PC and Log into the GUI” for procedures.
Step 2 Click the Provisioning > MS-SPRing tabs.
Step 3 Highlight the ring and click Delete.
Step 4 In the Suggestion dialog box, click OK.
Step 5 In the confirmation message, confirm that this is the ring you want to delete. If so, click Yes. Step 6 Return to your originating procedure (NTP).
Purpose | This task reroutes traffic from one source or destination to another on the |
| same circuit, thus changing the original source or destination. |
Tools/Equipment | None |
Prerequisite Procedures |
|
Required/As Needed | As needed |
Onsite/Remote | Onsite or remote |
Security Level | Provisioning or higher |
Step 1 From the View menu, choose Go To Network View.
Step 2 Click the Circuits tab.
Step 3 Click the circuit that you want to roll. The circuit must have a DISCOVERED status for you to start a roll.
| Cisco ONS 15600 SDH Procedure Guide, R8.0 |
| October 2007 |