Cisco Systems ONS 15600 SDH manual DLP-F348 View Circuit Information, 18-51

Chapter 18 DLPs F300 to F399

DLP- F348 View Circuit Information

On the network graphic, an F appears on the working MS-SPRing channel where you invoked the protection switch. The span lines change color to reflect the forced traffic. Green span lines indicate the new MS-SPRing path, and the lines between the protection switch are purple.

Performing a Force switch generates several conditions including FORCED-REQ-RING and WKSWPR.

Step 5 To apply a Force switch to the east line:

a.Right-click the east MS-SPRing port and choose Set East Protection Operation.

Note If node icons overlap, drag and drop the icons to a new location or return to network view and change the positions of the network node icons. MS-SPRing node icons are based on the network view node icon positions.

Note For two-fiber MS-SPRings, the squares on the node icons represent the MS-SPRing working and protect channels. You can right-click either channel.

b.In the Set East Protection Operation dialog box, choose FORCE RING from the drop-down list. Click OK.

c.Click Yes in the two Confirm MS-SPRing Operation dialog boxes that appear.

On the network graphic, an F appears on the working MS-SPRing channel where you invoked the protection switch. The span lines change color to reflect the forced traffic. Green span lines indicate the new MS-SPRing path, and the lines between the protection switch are purple.

Performing a Force switch generates several conditions including FORCED-REQ-RING and WKSWPR.

Step 6 From the File menu, choose Close.

Step 7 Return to your originating procedure (NTP).

DLP-F348 View Circuit Information

Purpose	This task enables you to view information about circuits, such as name,
	type, size, and direction.
Tools/Equipment	None
Prerequisite Procedures	DLP-F181 Log into CTC, page 16-34
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Retrieve or higher

Step 1 Navigate to the appropriate CTC view:

•To view circuits for an entire network, from the View menu, choose Go To Network View.

•To view circuits that originate, terminate, or pass through a specific node, from the View menu, choose Go To Other Node, then choose the node you want to search and click OK.

•To view circuits that originate, terminate, or pass through a specific card, in node view, double-click the card containing the circuits you want to view.

	Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007		18-51