XP SBC HC
Installation
English
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK, use only Philips SBC CS030/05)
1Make sure the adapter’s rated voltage corresponds to the mains socket voltage.
2Connect the DC connector of the AC/DC adapter to the 12 Volt DC power input connector located at the rear of the transmitter.
3Connect the 12 Volt/200 mA AC/DC adapter to the mains socket.
–Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time.
4Insert the antenna tube in the hole, located on the top of the transmitter. Ensure that the wire which is hanging out of that hole, is guided in the antenna tube.
–Installing the antenna tube correctly, will improve the transmission range.
Headphone power supply (figure 3)
IMPORTANT
Use only rechargeable LR03/AAA NiMH batteries (preferably Philips).
Do not use NiCd batteries or alkaline batteries as these may damage your FM wireless system!
1Check if the power button of the FM headphone is in the on position.
2To recharge the headphone’s
Notes:
Completely flat batteries need approximately 16 hours to recharge.
Always remove the batteries if the headphone is not to be used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.
Environmental Information
All redundant packing material has been omitted.We have done our best to make the packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
6