Tripp Lite SMX2200XLRT2U owner manual Quick Installation, Turn the UPS on

Quick Installation

1With the UPS disconnected from utility power, use a small tool to set the Voltage Dip Switches to match your input voltage. (All models are preset to the 230V setting.)

BATTERIES

1

2 Insert a user-supplied power cord
	(with country-specific plug) into
	the UPS System's IEC-320-C20
	AC input receptacle. Plug the
	cord into an AC wall outlet.*
	NOTE! after you plug the UPS into a live AC outlet,	2
	the UPS (in “Standby” mode) will automatically
	charge its batteries,** but will not supply power to
	its outlets until it is turned ON (see Step 3 below).
	* See Specifications for circuit amperage requirements.
	** The BATTERY CHARGE LED will be the only LED illuminated.
3	Find one of the power cords that
	came with the UPS. Insert the	3
	cord’s female plug into
	computer’s AC input. Insert the
	cord’s male plug into any UPS
	female output receptacle.
4	Plug your equipment into the UPS.*

Plug your equipment into the UPS. Repeat Step 3 above using the additional power cord(s) that came with the UPS.

Note: Additional interconnection cords (C13 to C14) are available from Tripp Lite. Call 773-869- 1234 (Part # P004-006).

*Your UPS is designed to support computer equipment only. You will overload the UPS if the total VA ratings for all the equipment you connect exceeds UPS output capacity. To find your equipment’s VA ratings, look on their nameplates. If the equipment is listed in amps, multiply the number of amps by 240 to determine VA. (Example: 1 amp × 240 = 240 VA). If you are unsure if you have overloaded your UPS's outlets, see “OUTPUT LOAD LEVEL” LED description.

4

5

5Turn the UPS ON.

Press and hold the “ON/OFF/STANDBY” button for one second. The alarm will beep once briefly after one second has passed. Release the button.

5