Q-Logic 2300 series manual Section QSB2340/2342

SANblade 2300 User’s Guide

2-Gb Fibre Channel to cPCI and SBus Host Bus Adapters

Q

3.3	Removing the QCP2340/2342 HBA	3-6
3.4	FCode	3-6
3.4.1	Updating FCode on the QCP2340/2342 HBA	3-7
3.4.2	Setting the QCP2340/2342 HBA Connection Mode	3-7
3.4.3	Setting the QCP2340/2342 HBA Loop ID	3-8
3.4.4	Selecting the Boot Device	3-9
3.4.5	Building the Bootable Disk	3-10
3.4.6	Setting and Viewing the Fibre Channel Data Rate	3-13
3.5	Specifications	3-13
3.6	Label	3-14
3.7	Agency Certification	3-14
3.7.1	EMI and EMC Requirements	3-14
3.7.2	Product Safety Requirements	3-15

Section 4	QSB2340/2342
4.1	QSB2340/2342 HBA Components	4-1
4.1.1	LEDs	4-2
4.1.2	Jumpers	4-2
4.2	Installation in the Computer	4-2
4.3	FCode	4-3
4.3.1	Updating FCode on the QSB2340/2342 HBA	4-3
4.3.2	Setting the QSB2340/2342 HBA Connection Mode	4-4
4.3.3	Setting the QSB2340/2342 HBA Loop ID	4-4
4.3.4	Selecting the Boot Device	4-5
4.3.5	Building the Bootable Disk	4-6
4.4	Specifications	4-9
4.5	Label	4-10
4.6	Agency Certification	4-10
4.6.1	EMI and EMC Requirements	4-10
4.6.2	Product Safety Requirements	4-11

Section 5	Troubleshooting
5.1	Problems After Installation	5-1
5.2	Hardware Problem Checklist	5-1
5.3	Fibre Channel Problem Checklist	5-1

Page iv CF2351102-00 F